LA42032 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LA42032
SANYO -> Panasonic
LA42032 Datasheet PDF : 7 Pages
| |||
External Components
LA42032
C1, C2 : Input coupling capacitors, for which 4.7μF or less is recommended. LA42032 employs the zero-bias type
input circuit, with the input pin potential being nearly zero. Accordingly, the polarity must be determined
according to the DC potential of a circuit connected to the previous stage of LA42032.
C3
: Capacitor for starting time of the ripple filter and amplifier, for which 47μF is recommended.
C4, R1 : Capacitor and resistor for mute. C4 is necessary even when the mute function is not used.
C5
: Power capacitor.
C6 to C9 : Capacitor and resistor for oscillation prevention. For C6 to C9, the polyester film capacitor with superior
R2 to R5 temperature characteristics (Mylar capacitor) is recommended. Use R2 to R5 of 2.2Ω along with the
capacitor.
1. Mute function (pin 6)
With the pin 6 voltage of 1.7V (minimum) or more, the mute function is turned ON.
Set the VM application voltage so that the pin 6 voltage becomes. 1.7V or more.
The mute time constant is determined by R1 and C4. Determine the constant after careful review because it is related
to the pop sound at mute ON/OFF.
C4 is necessary even when the mute function is not used because it is related to the pop sound when the amplifier is
turned ON.
Note that the MUTE pin (pin 6) incorporates the
anti-electrostatic diode, allowing the current to flow through the
diode when the potential of VCC 7 pin decreases below that of
pin 6.
Mute
R1
VM
6
C4 +
10μF
VCC
2kΩ
20kΩ
2kΩ
2. Standby function (pin 5)
The amplifier is turned ON when the voltage of 2.5V (minimum) or more is applied to pin 5.
Pin 5 control voltage
Pin 5 voltage
0 to 0.5
2.5 to VCC
Amplifier
OFF
ON
Standby
ON
OFF
To suppress the inrush current to pin 5 when the VSTB
application voltage is high, insert the control resistor (RSTB).
Standby
RSTB
VS
5
Example : Tosuppress the pin 5 inrush current to 500μA or less
RSTB
=
Applied
voltage
(VSTB) -2VBE
500μA
(About
1.4V)
-15kΩ
VCC
15kΩ
30kΩ
2VBE
1.5kΩ
Note that the standby pin (pin 5) incorporates the anti-electrostatic diode, allowing the cu orrent to flow through the
diode when the potential of VCC pin 7 decreases below that of pin 5.
No.A0855-4/7
Share Link: