HT80 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

제조사

HT80

turbocharger

Unspecified 

HC5A/HX80/82/83/85/HT4B/4C/80 Service Repair Manual

Turbocharger Service and Overhaul

Warning

If there is any possibility that the seal/s has been

subject to fire, always wear neoprene gloves when

handling.

Remove the thrust collar (36) and remove and discard

* * the seal/s (32) (27) .

Note

Air cooled bearing housings are fitted with o-ring seal

(32) only.

Warning

Always wear safety glasses.

Using suitable circlip pliers, remove and discard the two

* * circlips (64) and the journal bearing (11) from the

compressor end.

Turn the bearing housing over and repeat the process

of bearing removal at turbine end.

Inlet Baffle Option HX82/83

Where specified by the engine manufacturer, certain

turbochargers can have a pressed steel baffle fitted into

the inlet section.

This item is not serviceable and if damaged, must be

replaced, as the geometry of the part is critical to the

performance of the baffle.

To clean compressor housings always remove inlet

baffle.

Warning

Refer to Turbine and Compressor Housings for

removal instructions.

5:6

Share Link: