ZICM357P2-1C 데이터 시트보기 (PDF) - California Eastern Laboratories.

부품명

상세내역

제조사

ZICM357P2-1C

MeshConnect™ EM357 Module - Ember EM357 Transceiver Based Module

California Eastern Laboratories. 

MeshConnect™ EM357 Module

ensure that the information provided on the MeshConnect Label is placed on the outside of the final product. The

MeshConnect Module is labeled with its own FCC ID Number. If the FCC ID is not visible when the module is

installed inside another device, then the outside of the device into which the module is installed must also display

a label referring to the enclosed module. The exterior label can use wording such as the following:

• Contains Transmitter Module FCC ID: W7Z-ZICM357P2

• Contains FCC ID: W7Z-ZICM357P2

The OEM of the MeshConnect Module must only use the approved antenna, (PCB Trace Antenna) that has been

certified with this module. The OEM of the MeshConnect Module must test their final product configuration to

comply with Unintentional Radiator Limits before declaring FCC Compliance per Part 15 of the FCC Rules.

D IC Certification — Industry Canada Statement

E The term "IC" before the Certification/Registration Number only signifies that the Industry Canada technical

specifications were met.

D Certification IC - Déclaration d'Industrie Canada

N N Le terme "IC" devant le numéro de Certification/D'enregistrement signifie seulement que les spécifications

techniques Industrie Canada ont été respectées.

E IG Section 14 of RSS-210

The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field

in excess of Health Canada limits for the general population. Consult Safety Code 6, obtainable from Health Canada's

M S website: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-eng.php

M E L'article 14 du CNR-210

Le programme d'installation de cet équipement radio doit s'assurer que l'antenne est située ou orientée de

telle sorte qu'il ne pas émettre de champ RF au-delà des limites de Santé Canada pour la population générale.

O D Consulter le Code de sécurité 6, disponible sur le site Web de Santé Canada: http://www.hc-sc.gc.ca/ewh-semt/

pubs/radiation/radio_guide-lignes_direct-eng.php

C CE Certification — Europe

E W The MeshConnect RF t has been tested and certified for use in the European Union.

E OEM Responsibility to the European Union Compliance Rules

R If the MeshConnect Module is to be incorporated into a product, the OEM must verify compliance of the final

N product to the European Harmonized EMC and Low-Voltage/Safety Standards. A Declaration of Conformity must

be issued for each of these standards and kept on file as described in Annex II of the R&TTE Directive.

T The manufacturer must maintain the User Guide and adhere to the settings described in the manual for maintaining

O R European Union Compliance. If any of the specifications are exceeded in the final product, the OEM is required

to make a submission to the notified body for compliance testing.

N O OEM Labeling Requirements

F The CE mark must be placed on the OEM product in a visible location.The CE mark shall consist of the initials

CE with the following form:

• If the CE marking is reduced or enlarged, the proportions given in the above graduated

drawing must be adhered to.

• The CE mark must be a minimum of 5 mm in height.

• The CE marking must be affixed visibly, legibly, and indelibly. Since the 2400 - 2483.5 MHz

band is not harmonized by a few countries throughout Europe, the Restriction sign must be

placed to the right of the CE marking as shown in the picture.

Page 14

Share Link: