FDC37C669-MS 데이터 시트보기 (PDF) - SMSC -> Microchip

부품명

상세내역

제조사

FDC37C669-MS

PC 98/99 Compliant Super I/O Floppy Disk Controller with Infrared Support

SMSC -> Microchip 

STATUS REGISTER B (SRB)

Address F1 READ ONLY

This register is read-only and monitors the state of

several disk interface pins, in PS/2 and Model

30 modes. The SRB can be accessed at any time when

in PS/2 mode. In the PC/AT mode the data bus pins D0 -

D7 are held in a high impedance state for a read of

address 3F1.

PS/2 Mode

7

1

RESET 1

COND.

6

5

4

3

2

1

0

1 DRIVE WDATA RDATA WGATE MOT MOT

SEL0 TOGGLE TOGGLE

EN1 EN0

1

0

0

0

0

0

0

BIT 0 MOTOR ENABLE 0

Active high status of the MTR0 disk interface output pin.

This bit is low after a hardware reset and unaffected by a

software reset.

BIT 1 MOTOR ENABLE 1

Active high status of the MTR1 disk interface output pin.

This bit is low after a hardware reset and unaffected by a

software reset.

BIT 2 WRITE GATE

Active high status of the WGATE disk interface output.

BIT 3 READ DATA TOGGLE

Every inactive edge of the RDATA input causes this bit to

change state.

BIT 4 WRITE DATA TOGGLE

Every inactive edge of the WDATA input causes this bit to

change state.

BIT 5 DRIVE SELECT 0

Reflects the status of the Drive Select 0 bit of the DOR

(address 3F2 bit 0). This bit is cleared after a hardware

reset, it is unaffected by a software reset.

BIT 6 RESERVED

Always read as a logic "1".

BIT 7 RESERVED

Always read as a logic "1".

21

Share Link: