TECHNICAL DATA
KK1207
RECOMMENDED SOFTWARE PROGRAMMING FLOWCHART
START
SET
COMMAND 1
SET
COMMAND 2
SET
COMMAND 3
Clear Display RAM
(see Note 5)
SET
COMMAND 4
MAIN
PROGRAM
SET
COMMAND 1
SET
COMMAND2
SET
COMMAND 3
SET
COMMAND 4
INITIAL
SETTING
MAIN
LOOP
END
Note : 1. Command 1 : Display Mode Setting
2. Command 2 : Data Setting Commands
3. Command 3 : Address Setting Commands
4. Command 4 : Display Control Commands
5. When IC power is applied for the first time, the contents of the Display RAM are not defined : thus,
it is strongly suggested that the contents of the Display RAM must be cleared during the initial setting.
12