M41T0M(2008) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

M41T0M
(Rev.:2008)

Serial real-time clock

STMicroelectronics 

M41T0

3

Clock operation

Clock operation

Note:

The M41T0 is driven by a quartz controlled oscillator with a nominal frequency of

32.768 kHz. The accuracy of the real-time clock depends on the frequency of the quartz

crystal that is used as the time-base for the RTC. The M41T0 is tested to meet ± 35 ppm

with nominal crystal. The eight-byte clock register (see Table 3 on page 14) is used to both

set the clock and to read the date and time from the clock, in a binary coded decimal format.

Seconds, minutes, and hours are contained within the first three registers. Bits D6 and D7 of

clock register 2 (hours register) contain the CENTURY ENABLE bit (CEB) and the

CENTURY bit (CB). Setting CEB to a '1' will cause CB to toggle, either from '0' to '1' or from

'1' to '0' at the turn of the century (depending upon its initial state). If CEB is set to a '0', CB

will not toggle. Bits D0 through D2 of register 3 contain the day (day of week). Registers 4, 5

and 6 contain the date (day of month), month and years. The final register is the control

register. Bit D7 of register 0 contains the STOP bit (ST). Setting this bit to a '1' will cause the

oscillator to stop. If the device is expected to spend a significant amount of time on the shelf,

the oscillator may be stopped to reduce current drain. When reset to a '0' the oscillator

restarts within four seconds (typically one second).

The seven clock registers may be read one byte at a time, or in a sequential block. The

control register (address location 7) may be accessed independently. Provision has been

made to assure that a clock update does not occur while any of the seven clock addresses

are being read. If a clock address is being read, an update of the clock registers will be

delayed by 250 ms to allow the READ to be completed before the update occurs. This will

prevent a transition of data during the READ.

This 250 ms delay affects only the clock register update and does not alter the actual clock

time.

3.1

Note:

Output driver pin

The OUT pin is an output driver that reflects the contents of D7 of the control register. In

other words, when D7 of location 7 is a '0' then the OUT pin will be driven low.

The OUT pin is open drain which requires an external pull-up resistor.

3.2

Oscillator stop detection

If the oscillator fail (OF) bit is internally set to a '1,' this indicates that the oscillator has either

stopped, or was stopped for some period of time and can be used to judge the validity of the

clock and date data. This bit will be set to '1' any time the oscillator stops. The following

conditions can cause the OF bit to be set:

● The first time power is applied (defaults to a '1' on power-up).

● The voltage present on VCC is insufficient to support oscillation.

● The ST bit is set to '1.'

● External interference or removal of the crystal.

This bit will remain set to '1' until written to logic '0.'

The oscillator must start and have run for at least 4 seconds before attempting to reset the

OF bit to '0.' This function operates both under normal power and in battery backup.

13/22

Share Link: