MAX1211(2003) 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX1211 Datasheet PDF : 29 Pages
| |||
65Msps, 12-Bit, IF Sampling ADC
Package Information
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information,
go to www.maxim-ic.com/packages.)
D
D/2
E/2
E
A
A1 A2
D2
CL
b
k
D2/2
(NE-1) X e
E2/2
CL E2
e
(ND-1) X e
k
L
CL
L
e
CL
L
e
PACKAGE OUTLINE
36,40L QFN THIN, 6x6x0.8 mm
21-0141
C
1
2
COMMON DIMENSIONS
EXPOSED PAD VARIATIONS
PKG.
CODES
T3666-1
T4066-1
D2
E2
MIN. NOM. MAX. MIN. NOM. MAX.
3.60 3.70 3.80 3.60 3.70 3.80
4.00 4.10 4.20 4.00 4.10 4.20
NOTES:
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
FROM TERMINAL TIP.
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220.
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
PACKAGE OUTLINE
36, 40L QFN THIN, 6x6x0.8 mm
21-0141
C
2
2
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 ____________________ 29
© 2003 Maxim Integrated Products
Printed USA
is a registered trademark of Maxim Integrated Products.
Share Link: 