ADF7010BRU 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

ADF7010BRU

High Performance ISM Band ASK/FSK/GFSK Transmitter IC

Analog Devices 

ADF7010

DVDD

REGULATOR READY

DIGITAL LOCK DETECT

ANALOG LOCK DETECT

R COUNTER/2 OUTPUT

MUX

CONTROL

MUXOUT

N COUNTER/2 OUTPUT

R COUNTER OUTPUT

N COUNTER OUTPUT

TE Figure 5. MUXOUT Stage

DGND

Digital Lock Detect

E Digital lock detect is active high. The lock detect circuit is

contained at the PFD. When the phase error on five consecutive

cycles is less than 15 ns, lock detect is set high. Lock detect

remains high until 25 ns phase error is detected at the PFD. Since

L no external components are needed for digital lock detect, it is

more widely used than analog lock detect.

Analog Lock Detect

This N-channel open-drain lock detect should be operated with

O an external pull-up resistor of 10 kW nominal. When lock has been

detected, this output will be high with narrow low going pulses.

VOLTAGE REGULATOR

S The ADF7010 requires a stable voltage source for the VCO and

modulation blocks. The on-board regulator provides 2.2 V using

a band gap reference. A 2.2 mF capacitor from CREG to ground

is used to improve stability of the regulator over a supply from 2.3 V

B to 3.6 V. The regulator consumes less than 400 mA and can only

be powered down using the chip enable (CE) pin. Bringing

the chip enable pin low disables the regulator and also erases all

values held in the registers. The serial interface operates off the

regulator supply; therefore, to write to the part, the user must

O have CE high. Regulator status can be monitored using the

CHARGE

PUMP OUT

VCO

Figure 6. Typical Loop Filter Configuration––

Third Order Integrator

In FSK, the loop should be designed so that the loop bandwidth

(LBW) is approximately 5 times the data rate. Widening the LBW

excessively reduces the time spent jumping between frequencies

but may cause insufficient spurious attenuation.

For ASK systems, the wider the loop BW the better. The sudden

large transition between two power levels will result in VCO

pulling and can cause a wider output spectrum than is desired. By

widening the loop BW to >10 times the data rate, the amount

of the VCO pulling is reduced, since the loop will settle quickly

back to the correct frequency. The wider LBW may restrict the

output power and data rate of ASK based systems, compared

with FSK based systems.

Regulator Ready signal from MUXOUT.

Narrow loop bandwidths may result in the loop taking long

periods of time to attain lock. Careful design of the loop filter is

LOOP FILTER

critical in obtaining accurate FSK/GFSK modulation.

The loop filter integrates the current pulses from the charge

pump to form a voltage that tunes the output of the VCO to the

desired frequency. It also attenuates spurious levels generated

by the PLL. A typical loop filter design is shown in Figure 6.

For GFSK, it is recommended that an LBW of 2.0 to 2.5 times

the data rate be used to ensure sufficient samples are taken of the

input data while filtering system noise.

–16–

REV. 0

Share Link: