AS1116-BSST(2009) 데이터 시트보기 (PDF) - austriamicrosystems AG

부품명

상세내역

제조사

AS1116-BSST
(Rev.:2009)

64 LED Driver with Detailed Error Detection

austriamicrosystems AG 

AS1116

Datasheet - Detailed Description

Feature Register (0x0E)

The Feature Register is used for enabling various features including switching the device into external clock mode,

applying an external reset, selecting code-B or HEX decoding, enabling or disabling blinking, enabling or disabling the

SPI-compatible interface, setting the blinking rate, and resetting the blink timing.

Note: At power-up the Feature Register is initialized to 0.

Table 19. Feature Register Summary

D7

blink_

start

D6

sync

D5

blink_

freq_sel

D4

blink_en

D3

D2

D1

NU

decode_sel reg_res

D0

clk_en

Table 20. Feature Register Bit Descriptions (Address (HEX) = 0xXE)

Addr: 0xXE

Feature Register

Enables and disables various device features.

Bit Bit Name Default Access

Bit Description

External clock active.

D0

clk_en

0

R/W 0 = Internal oscillator is used for system clock.

1 = Pin CLK of the serial interface operates as system clock input.

Resets all control registers except the Feature Register.

0 = Reset Disabled. Normal operation.

D1 reg_res

0

R/W 1 = All control registers are reset to default state (except the Feature

Register) identically after power-up.

D2 decode_sel

0

Note: The Digit Registers maintain their data.

Selects display decoding for the selected digits (Table 9 on page 10).

R/W 0 = Enable Code-B decoding (see Table 10 on page 11).

1 = Enable HEX decoding (see Table 11 on page 11).

D3

NU

D4 blink_en

0

D5 blink_freq_sel

0

D6

sync

0

D7 blink_start

0

Not used

Enables blinking.

R/W 0 = Disable blinking. 1 = Enable blinking.

Sets blink with low frequency (with the internal oscillator enabled):

R/W 0 = Blink period typically is 1 second (0.5s on, 0.5s off).

1 = Blink period is 2 seconds (1s on, 1s off).

Synchronizes blinking on the rising edge of pin LD. The multiplex and

R/W

blink timing counter is cleared on the rising edge of pin LD. By setting

this bit in multiple devices, the blink timing can be synchronized across

all the devices.

Start Blinking with display enabled phase. When bit D4 (blink_en) is set,

bit D7 determines how blinking starts.

R/W 0 = Blinking starts with the display turned off.

1 = Blinking starts with the display turned on.

No-Op Register (0xX0)

The No-Op Register is used when multiple AS1116 devices are cascaded in order to support displays with more than 8

digits. The cascading must be done in such a way that all SDO pins are connected to SDI of the next AS1116 (see Fig-

ure 20 on page 16). The LD and SCL signals are connected to all devices.

For example, if five devices are cascaded, in order to perform a write operation to the fifth device, the write-command

must be followed by four no-operation commands. When the LD signal goes high, all shift registers are latched. The

first four devices will receive no-operation commands and only the fifth device will receive the intended operation com-

mand, and subsequently update its register.

www.austriamicrosystems.com

Revision 1.04

14 - 20

Share Link: