DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

FA5526 데이터 시트보기 (PDF) - Fuji Electric

부품명
상세내역
제조사
FA5526 Datasheet PDF : 33 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
FA5526/5527/5528/5536/5537/5538
At start-up, soft start can be realized through gradually
increasing the threshold voltage based on CS pin
voltage.
At steady operation, the threshold voltage is varied
based on FB pin voltage to keep power supply output
voltage constant.
In addition, the maximum IS pin threshold voltage as
520mV limits MOSFET over-current when FB pin voltage
is very high like 4V by overload etc.
Cs
5V
CS
1
FB
Buf
2
x1
60k 3R
VCC
11µA
IS comp.
The oscillator generates a pulse to determine the
maximum duty cycle of an OUT pulse and the maximum
20k
R
0.52V
duty cycle is set at 80% (typ.) using this pulse..
For details, refer to “9-(14) Timing chart”.
3
IS
Rs
Fig.7 Current comparator
(4) Blanking
When MOSFET turns on, a surge current is generated
due to discharge current from the capacitor in the main
circuit or gate drive current. If the surge current reaches
the IS pin threshold voltage, current comparator output
could be inverted and normal pulses would not be
generated from the OUT pin.
To avoid this, a blanking function is incorporated into
the current comparator. When a trigger signal is input
from the oscillator, the blanking circuit outputs a
certain-width pulse signal as a PWM latch (F.F.) set
signal.
Since the set signal is given a high priority in PWM
latch input signals, the output of PWM latch (F.F.) will not
be inverted while the set signal is input from the blanking
circuit, even if a rest signal is input from the current
comparator (IS comp.).
As a result, the IS pin input voltage is ignored for a
blanking time (200ns for FA5526/36, 400ns for
FA5527/37 and 600ns for FA5528/38) immediately after
an output pulse has been generated from the OUT pin
and does not respond to a surge current at turn-on.
See Fig.8.
In general, the blanking circuit eliminates the need for
a noise filter at the IS pin.
Fig.8 Blanking
Fuji Electric Co., Ltd.
AN-087E Rev.1.0
April-2011
17
http://www.fujielectric.co.jp/products/semiconductor/

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]