IR3094PBF 데이터 시트보기 (PDF) - International Rectifier
부품명
상세내역
제조사
IR3094PBF Datasheet PDF : 29 Pages
| |||
IR3094PBF
Since the voltage drop in the body diode is often higher than output voltage, the inductor current slew rate can be
increased by 2X or more. This patent pending technique is referred to as “body braking” and is accomplished
through the “0% Duty Cycle Comparator”. If the Error Amplifier’s output voltage drops below 0.575V, this
comparator turns off the low side gate driver.
Figure 4 depicts PWM operating waveforms under various conditions
CLK1
PULSE
EAOUT
PWM 0.6V
Ramp1
GATEH1
0.575V
GATEL1
STEADY-STATE
OPERATION
DUTY CYCLE INCREASE
DUE TO LOAD
INCREASE
DUTY CYCLE DECREASE DUE TO LOAD
DECREASE (BODY BRAKING) OR FAULT
STEADY-STATE
OPERATION
Figure 4 – PWM Operating Waveforms
Current Sense Amplifier
A high speed differential current sense amplifier is shown in Figure 5. Its gain decreases with increasing
temperature and is nominally 24 at 25ºC and 20.9 at 125ºC (-1400 ppm/ºC). This reduction of gain tends to
compensate the 3850 ppm/ºC increase in inductor DCR. Since in most designs the IR3094 IC junction is hotter than
the inductors these two effects tend to cancel such that no additional temperature compensation of the load line is
required.
The current sense amplifier can accept positive differential input up to 75mV and negative up to -25mV before
clipping. The output of the current sense amplifier is summed with the VREF voltage which is used for over current
protection, voltage positioning and current sharing.
vL
iL L
RL
Rs Cs
CSA
vc
CO
Vo
Co
Figure 5 – Inductor Current Sensing and Current Sense Amplifier
Page 13 of 29
09/26/05
Share Link: 