DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

LA76075 데이터 시트보기 (PDF) - SANYO -> Panasonic

부품명
상세내역
제조사
LA76075 Datasheet PDF : 35 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
LA76075
SIF (FM) Block Input Signals and Measurement Conditions
Unless otherwise specified for the items, apply the following conditions.
1.Use the following bus control condition: IF.AGC.DEF = “1.”
2. SW:IF1 = “ON”
3. Apply the input signal to pin 49. Use a carrier frequency of 4.5 MHz.
Item
FM output level
FM limiting sensitivity
FM f characteristic
(fm = 50 Hz)
FM f characteristic
(fm = 100 Hz)
FM total harmonic
distortion
AM rejection
SIF signal-to-noise ratio
Symbol
SOADJ
SLS
SF50
SF100K
STHD
SAMR
SSN
Measurement
Point
Input
Signal
Measurement Procedure
Bus Condition
7
90 dBµ,
fm = 400 Hz,
FM = ±25 kHz
Adjust the DAC FM.LEVEL to bring the 400 Hz
component of the pin 7 FM wave detection output as
close as possible to 474 mVrms. Measure SV1, the
output level (mVrms).
7
fm = 400 Hz,
FM = ±25 kHz
Determine the input level (dBµ) at which the 400 Hz
component of the pin 7 FM wave detection output is -3
dB relative to SV1.
FM.LEVEL = adjusted
value
7
90 dBµ,
fm = 50 Hz,
FM = ±25 kHz
Set SW:IF1 to “OFF.” Measure SV2, the output level
(mVrms) for the pin 7 FM wave detection output, and
substitute in the following formula.
SF50 = 20 × LOG(SV1/SV2) [dB]
FM.LEVEL = adjusted
value
7
90 dBµ,
fm = 100 Hz,
FM = ±25 kHz
Set SW:IF1 to “OFF.” Measure SV3, the output level
(mVrms) for the pin 7 FM wave detection output, and
substitute in the following formula.
SF100K = 20 × LOG(SV1/SV2) [dB]
FM.LEVEL = adjusted
value
7
90 dBµ,
fm = 400 Hz,
FM = ±25 kHz
Determine the total harmonic distortion for the 400-Hz
component of the pin 7 FM wave detection output.
FM.LEVEL = adjusted
value
7
90 dBµ,
fm = 400 Hz,
AM = 30%
Measure SV4, the 400 Hz component (mVrms) of the
pin 7 FM wave detection output, and substitute in the FM.LEVEL = adjusted
following formula.
value
SAMR = 20 × LOG(SV1/SV4) [dB]
7
90 dBµ,
CW
Measure SV5, the noise level (mVrms) at pin 7, and
substitute in the following formula.
SSN = 20 × LOG(SV1/SV5) [dB]
FM.LEVEL = adjusted
value
No. 5845-15/35

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]