LPC1102UK 데이터 시트보기 (PDF) - NXP Semiconductors.
부품명
상세내역
제조사
LPC1102UK Datasheet PDF : 43 Pages
| |||
NXP Semiconductors
LPC1102/1104
32-bit ARM Cortex-M0 microcontroller
8. Limiting values
Table 4. Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134).[1]
Symbol
Parameter
Conditions
Min
Max
Unit
VDD
supply voltage (core and external rail)
[2] 0.5
+4.6
V
VI
input voltage
5 V tolerant I/O
[2][3] 0.5
+5.5
V
pins; VDD 1.8 V
VDD = 0 V
0.5
+3.6
V
VIA
analog input voltage
pin configured as
[2][4] 0.5
+4.6
V
analog input
IDD
ISS
Ilatch
Tstg
Tj(max)
Ptot(pack)
VESD
supply current
ground current
I/O latch-up current
storage temperature
maximum junction temperature
total power dissipation (per package)
electrostatic discharge voltage
per supply pin
per ground pin
(0.5VDD) < VI <
(1.5VDD);
Tj < 125 C
non-operating
based on package
heat transfer, not
device power
consumption
human body
model; all pins
[5] -
[5] -
-
[6] 65
-
-
[7]
100
mA
100
mA
100
mA
+150
C
150
C
1.5
W
6 500
V
[1] The following applies to the limiting values:
a) This product includes circuitry specifically designed for the protection of its internal devices from the damaging effects of excessive
static charge. Nonetheless, it is suggested that conventional precautions be taken to avoid applying greater than the rated
maximum.
b) Parameters are valid over operating temperature range unless otherwise specified. All voltages are with respect to VSS unless
otherwise noted.
c) The limiting values are stress ratings only. Operating the part at these values is not recommended and proper operation is not
guaranteed. The conditions for functional operation are specified in Table 5.
[2] Maximum/minimum voltage above the maximum operating voltage (see Table 5) and below ground that can be applied for a short time
(< 10 ms) to a device without leading to irrecoverable failure. Failure includes the loss of reliability and shorter lifetime of the device.
[3] Including voltage on outputs in 3-state mode.
[4] See Table 6 for maximum operating voltage.
[5] The peak current is limited to 25 times the corresponding maximum current.
[6] The maximum non-operating storage temperature is different than the temperature for required shelf life which should be determined
based on required shelf lifetime. Please refer to the JEDEC spec (J-STD-033B.1) for further details.
[7] Human body model: equivalent to discharging a 100 pF capacitor through a 1.5 k series resistor.
LPC1102_1104
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 7 — 26 September 2013
© NXP B.V. 2013. All rights reserved.
18 of 43
Share Link: 