LQ10D368 데이터 시트보기 (PDF) - Sharp Electronics

부품명

상세내역

제조사

LQ10D368

TFT-LCD Module

Sharp Electronics 

sharp

10. Display Quality

The display quality of the color TFT-LCD module shall be in compliance with the

Incoming Inspection Standard.

LD13305‑15

11．Handling Precautions

a) Be sure to turn off the power supply when inserting or disconnecting the cable.

b) Be sure to design the cabinet so that the module can be installed without any extra stress such as

warp or twist.

c) Since the front polarizer is easily damaged, pay attention not to scratch it.

d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.

e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.

f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.

Handle with care.

g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth

when handling.Observe all other precautionary requirements in handling electric components.

h) Protection film is attached to the module surface to prevent it from being scratched .

Peel the film off slowly , just before the use, with strict attention to electrostatic charges.

Blow off 'dust' on the polarizer by using an ionized nitrogen.

. i) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching

protective board over the LCD, be careful about the optical interface fringe etc. which degrades display

quality.

j)Do not expose the LCD panel to direct sunlight. Lightproof shade etc. should be attached when LCD panel is

used under such environment.

k) Connect GND to 4 place of mounting holes to stabilize against EMI and external noise.

l) There are high voltage portions on the backlight and very dangerous. Careless touch may lead to

electrical shock. When exchange lamps or service, turn off the power without tail.

m) When handling LCD modules and assembling them into cabinets, please be noted that long-term

storage in the environment of oxidization or deoxidization gas and the use of such materials as reagent,

solvent, adhesive, resin, etc. which generate these gasses, may cause corrosion and discoloration of the

LCD modules.

n)Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local

ordinances or regulations for disposal.

o) Be sure not to aplly tensile stress to the lamp lead cable.

12.Packing form

Product country

JAPAN

Piling number of cartons

8（Max）

Packing quantity in one carton 10

Carton size [mm]

497(W)×318(D)×227(H)

Total mass of one carton filled 7.8 kg

with full modules

Packing form is shown

Fig.4

Share Link: