M41T56(2006) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

M41T56
(Rev.:2006)

Serial real-time clock with 56 bytes NVRAM

STMicroelectronics 

M41T56

Operation

2.3

WRITE mode

In this mode the master transmitter transmits to the M41T56 slave receiver. Bus protocol is

shown in Figure 11 on page 13. Following the START condition and slave address, a logic '0'

(R/W = 0) is placed on the bus and indicates to the addressed device that word address An

will follow and is to be written to the on-chip address pointer. The data word to be written to

the memory is strobed in next and the internal address pointer is incremented to the next

memory location within the RAM on the reception of an acknowledge clock. The M41T56

slave receiver will send an acknowledge clock to the master transmitter after it has received

the slave address and again after it has received the word address and each data byte (see

Figure 8 on page 12).

2.4

Data retention mode

With valid VCC applied, the M41T56 can be accessed as described above with READ or

WRITE cycles. Should the supply voltage decay, the M41T56 will automatically deselect,

write protecting itself when VCC falls between VPFD (max) and VPFD (min). This is

accomplished by internally inhibiting access to the clock registers and SRAM. When VCC

falls below the Battery Back-up Switchover Voltage (VSO), power input is switched from the

VCC pin to the battery and the clock registers and SRAM are maintained from the attached

battery supply.

All outputs become high impedance. On power up, when VCC returns to a nominal value,

write protection continues for tREC.

For a further more detailed review of battery lifetime calculations, please see Application

Note AN1012.

Figure 11. WRITE mode sequence

BUS ACTIVITY:

MASTER

SDA LINE

S

WORD

ADDRESS (n)

DATA n

BUS ACTIVITY:

SLAVE

ADDRESS

DATA n+1

DATA n+X P

AI00591

13/28

Share Link: