MAX492 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

MAX492

Single/Dual/Quad, Micropower, Single-Supply Rail-to-Rail Op Amps

Maxim Integrated 

Single/Dual/Quad, Micropower,

Single-Supply Rail-to-Rail Op Amps

The MAX492/MAX494/MAX495 can drive capacitive

loads in excess of 1000pF under certain conditions

(Figure 5). When driving capacitive loads, the greatest

potential for instability occurs when the op amp is

sourcing approximately 100µA. Even in this case, sta-

bility is maintained with up to 400pF of output capaci-

tance. If the output sources either more or less current,

stability is increased. These devices perform well with a

1000pF pure capacitive load (Figure 6). Figure 7 shows

the performance with a 500pF load in parallel with vari-

ous load resistors.

To increase stability while driving large capacitive

loads, connect a pull-up resistor at the output to

decrease the current that the amplifier must source. If

the amplifier is made to sink current rather than source,

stability is further increased.

Frequency stability can be improved by adding an out-

put isolation resistor (RS) to the voltage-follower circuit

(Figure 8). This resistor improves the phase margin of

the circuit by isolating the load capacitor from the op

amp’s output. Figure 9a shows the MAX492 driving

10,000pF (RL ≥ 100kΩ), while Figure 9b adds a 47Ω

isolation resistor.

MAX49_

VIN

RS

VOUT

CL

Figure 8. Capacitive-Load Driving Circuit

VIN

50mV/div

VOUT

50mV/div

10µs/div

Figure 9b. Driving a 10,000pF Capacitive Load with a 47Ω

Isolation Resistor

VIN

50mV/div

VOUT

50mV/div

10µs/div

Figure 9a. Driving a 10,000pF Capacitive Load

+5V

VCC

2

1k

7

6

MAX495

VOUT

3

4

1k

Figure 10. Power-Up Test Configuration

______________________________________________________________________________________ 13

Share Link: