MB89185LPFV 데이터 시트보기 (PDF) - Fujitsu

부품명

상세내역

제조사

MB89185LPFV

8-bit Proprietary Microcontroller

Fujitsu 

MB89180L Series

s HANDLING DEVICES

1. Preventing Latchup

Latchup may occur on CMOS ICs if voltage higher than VCC or lower than VSS is applied to input and output pins

other than medium- to high-voltage pins or if higher than the voltage which shows on “1. Absolute Maximum

Ratings” in sELECTRICAL CHARACTERISTICS is applied between VCC to VSS.

When latchup occurs, power supply current increases rapidly and might thermally damage elements. When

using, take great care not to exceed the absolute maximum ratings.

2. Treatment of Unused Input Pins

Leaving unused input pins open could cause malfunctions. They should be connected to a pull-up or pull-down

resistor.

3. Treatment of N.C. Pin

Be sure to leave (internally connected) N.C. pins open.

4. Power Supply Voltage Fluctuations

Although VCC power supply voltage is assured to operate within the rated range, a rapid fluctuation of the voltage

could cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied to the IC is therefore

important. As stabilization guidelines, it is recommended to control power so that VCC ripple fluctuations (P-P

value) will be less than 10% of the standard VCC value at the commercial frequency (50 Hz to 60 Hz) and the

transient fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when power

is switched.

5. Precautions when Using an External Clock

Even when an external clock is used, oscillation stabilization time is required for power-on reset (optional) and

wake-up from stop mode.

6. Note to Noise in the External Reset Pin (RST)

If the reset pulse applied to the external reset pin (RST) does not meet the specifications, it may cause malfunc-

tions. Use caution so that the reset pulse less than the specifications will not be fed to the external reset pin (RST) .

15

Share Link: