DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MC68CK338CPV14B1 데이터 시트보기 (PDF) - Freescale Semiconductor

부품명
상세내역
제조사
MC68CK338CPV14B1
Freescale
Freescale Semiconductor Freescale
MC68CK338CPV14B1 Datasheet PDF : 133 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
Freescale Semiconductor, Inc.
3.3 System Clock
The system clock in the SIML provides timing signals for the IMB modules and for an external peripheral
bus. Because the MCU is a fully static design, register and memory contents are not affected when the
clock rate changes. System hardware and software support changes in clock rate during operation.
The system clock signal can be generated in one of two ways. An internal phase-locked loop can
synthesize the clock from a reference frequency, or the clock signal can be input directly from an
external source. Keep these clock sources in mind while reading the rest of this section. Figure 5 is a
block diagram of the system clock.
MODCLK EXTAL XTAL
XFC
VDDSYN
CLKOUT
CRYSTAL
OSCILLATOR
PHASE
COMPARATOR
LOW-PASS
FILTER
VCO
W
FEEDBACK DIVIDER
Y
X
SYSTEM CLOCK CONTROL
SYSTEM
CLOCK
Figure 5 System Clock Block Diagram
16/32 PLL BLOCK
3.3.1 Clock Sources
The state of the clock mode (MODCLK) pin during reset determines the system clock source. When
MODCLK is held high during reset, the clock synthesizer generates a clock signal from a reference
frequency connected to the EXTAL pin. The clock synthesizer control register (SYNCR) determines
operating frequency and mode of operation. When MODCLK is held low during reset, the clock
synthesizer is disabled and an external system clock signal must be applied. The SYNCR control bits
have no effect.
The input clock is referred to as “fref”, and can be either a crystal or an external clock source. The output
of the clock system is referred to as “fsys”. Ensure that fref and fsys are within normal operating limits.
The reference frequency for this MCU is typically 32.768 kHz, but can range from 25 kHz to 50 kHz. To
generate a reference frequency using the crystal oscillator, a reference crystal must be connected be-
tween the EXTAL and XTAL pins. Figure 6 shows a recommended circuit.
MOTOROLA
16
For More Information On This Product,
Go to: www.freescale.com
MC68CK338
MC68CK338TS/D

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]