MLX90129RGO-CAA-000-RE(2012) 데이터 시트보기 (PDF) - Melexis Microelectronic Systems
부품명
상세내역
제조사
MLX90129RGO-CAA-000-RE Datasheet PDF : 60 Pages
| |||
MLX90129
13.56MHZ SENSOR TAG / DATALOGGER IC
Address
#12
#13
#14
#15
#16
#17
#18
#19
#1A
#1B
#1C
#1D
#1E
#1F
#20
#21
#22
#23
#24
#25
#26
#27
#28
Description
Sensors common configuration space
Sensor power configuration word
(reserved)
Sensor trimming configuration word
Sensor 0 configuration space
Sensor 0: Sensor control word
Sensor 0: Sensor low threshold word
Sensor 0: Sensor high threshold word
Sensor 0: Sensor signal conditioner configuration word
Sensor 0: Sensor connections configuration word
Sensor 0: Sensor resistance configuration word
Sensor 1 configuration space
Sensor 1: Sensor control word
Sensor 1: Sensor low threshold word
Sensor 1: Sensor high threshold word
Sensor 1: Sensor signal conditioner configuration word
Sensor 1: Sensor connections configuration word
Sensor 1: Sensor resistance configuration word
Sensor 2 configuration space
Sensor 2: Sensor control word
Sensor 2: Sensor low threshold word
Sensor 2: Sensor high threshold word
Sensor 2: Sensor signal conditioner configuration word
Sensor 2: Sensor connections configuration word
Sensor 2: Sensor resistance configuration word
EE-Latches backup space
Internal device backup word 1
Internal device backup word 2
Page 47
Page 47
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 48
Page 14
Page 14
(**) In the register file, this configuration space is updated from the appropriate part of the Extended sensor
configuration space at each access to one of the three sensors. This configuration space and all others with
higher addresses are not updated during a Register File Update operation.
7.4.2 Update of the Register File
The EEPROM contains the initial image of
the Register File. This image is copied after
the power-on, upon a SPI / RFID Update
request. The sensor configuration in the
Register File depends on the currently
selected sensor. The sensor is selected
either manually by reading the ADC buffer
corresponding or automatically during a
standalone application.
3901090129
Rev 009
Page 16 of 60
Data Sheet
Jun/12
Share Link: 