MLX90129
13.56MHZ SENSOR TAG / DATALOGGER IC
Sensor serial resistance conditioner words (EEPROM & Register, addresses #1A. EEPROM only #20
and #26)
Each of the 3 sensors called Sensor0, Sensor1, and Sensor2 can be connected to some serial resistances in
order to reduce their current consumption, or to set their common-mode level.
Bits Name
Content
#1A - Sensor 0 serial resistance configuration word
15 Sensor0_Temp_ En
Bit[15]=1 -> enables the temperature sensor
14:0 Sensor0_Res_Cfg
Resistance network configuration:
Bit[0] (not used=0)
Bit[1]=1 → SENSSUP2 = VREF
Bit[2]=1 → SENS3 = VREF
Bit[3] (not used=0)
Bit[4]=1 → SENSSUP2 = VSS
Bit[5]=1 → SENS4 = VSS
Bit[6]=1 → VCM = VREF/2 (enabled)
Bit[7]=1 → connects programmable resistance 1 to VREF
Bit[8]=1 → connects programmable resistance 2 to VSS
Bit[9] (not used=0)
Bit[10]=1 → connects programmable resistance 1 to SENSSUP2
Bit[11]=1 → connects programmable resistance 1 to SENS3
Bit[12] (not used=0)
Bit[13]=1 → connects programmable resistance 2 to SENSSUP2
Bit[14]=1 → connects programmable resistance 2 to SENS4
#20 - Sensor 1 serial resistance configuration word
15:0 Same as above
Same as above
#26 - Sensor 2 serial resistance configuration word
15:0 Same as above
Same as above
3901090129
Rev 009
Page 51 of 60
Data Sheet
Jun/12