Philips Semiconductors
Car radio Digital Signal Processor (DSP)
Product specification
SAA7706H
1 FEATURES
1.1 Hardware
• 5-bitstream 3rd-order sigma-delta Analog-to-Digital
Converters (ADCs) with anti-aliasing broadband input
filter
• 1-bitstream 1st-order sigma-delta ADC with anti-aliasing
broadband input filter
• 4-bitstream Digital-to-Analog Converters (DACs) with
128-fold oversampling and noise shaping
• Integrated semi-digital filter; no external post filter
required for DAC
• Dual media support: allowing separate front-seat and
rear-seat signal sources and separate control
• Simultaneous radio and audio processing
• Digital FM stereo decoder
• Digital FM interference suppression
• RDS demodulation via separate ADC; with buffered
output option
• Two mono Common-Mode Rejection Ratio (CMRR)
input stages for voice signals from phone and navigation
inputs
• Phone and navigation mixing at DAC front outputs
• Two stereo CMRR input stages (CD-walkman and
CD-changer etc.)
• Analog single-ended TAPE and AUX input
• Separate AM-left and AM-right inputs in the event of use
of external AM stereo decoder
• One digital input: I2S-bus or LSB-justified format
• Two digital inputs: SPDIF format
• Co-DSP support via I2S-bus or LSB-justified format
• Audio output short-circuit protected
• I2C-bus controlled (including fast mode)
• MOST bus interfacing (details in separate manual)
• Phase-locked loop derives the internal clocks from one
common fundamental crystal oscillator
• Combined AM/FM level input
• Pin compatible with SAA7705 and SAA7708
• All digital inputs are tolerant of 5 V input levels
• All analog inputs have high GSM immunity
• Low number of external components required
• −40 to +85 °C operating temperature range
• Easy applicable.
1.2 Software
• Improved FM weak signal processing
• Integrated 19 kHz MPX filter; de-emphasis and stereo
detection
• Electronic adjustments: FM or AM level, FM channel
separation, Dolby®(1) level
• Baseband audio processing (treble, bass, balance,
fader and volume)
• Four channel 5-band parametric equalizer
• 9-bands mono audio spectrum analyzer
• Extended beep functions with tone sequencer for phone
rings
• Large volume jumps e-power interpolated to prevent
zipper noise
• Dual media support; allowing separate front-seat and
rear-seat signal sources and separate control
• Dynamic loudness or bass boost
• Audio level monitor
• Tape equalization and Music Search System (MSS)
detection for tape
• Dolby-B tape noise reduction (at 44.1 kHz only)
• Dynamics compression available in all modes
• CD de-emphasis processing
• Voice-over possibility for phone and navigation signals
• Improved AM signal processing
• Digital AM CQUAM stereo decoder (not in all
rom_codes available)
• Digital AM interference suppression
• Soft audio mute
• RDS update processing: pause detection, mute and
signal-quality sensor-freeze
• General purpose tone generator
(1) Dolby — Available only to licensees of Dolby Laboratories
Licensing Corporation, San Francisco, CA94111, USA, from
whom licensing and application information must be obtained.
Dolby is a registered trade-mark of Dolby Laboratories
Licensing Corporation.
2001 Mar 05
3