SI3016-BS 데이터 시트보기 (PDF) - Silicon Laboratories
부품명
상세내역
제조사
SI3016-BS Datasheet PDF : 50 Pages
| |||
Si3016
Table 4. AC Characteristics (Continued)
(TA = 0 to 70 °C for K-Grade and –40 to 85 °C for B-Grade; see Figure 6 on page 9)
Parameter
Symbol
Test Condition
Min
Typ Max Unit
Caller ID Full Scale Level (0 dB gain)
VCID
MODE = 0
—
0.8
—
VPP
Caller ID Full Scale Level (ARX = 00) VCID
MODE = 1
—
1.4
—
VPP
Gain Accuracy5,6
2-W to SDO, ATX and –0.5
0
0.5
dB
ARX = 000, 001, or 010
Gain Accuracy5,6
2-W to SDO, ATX and
–1
0
1
dB
ARX = 011, 1xx
Notes:
1. Measured at TIP and RING with 600 Ω termination at 1 kHz, as shown in Figure 1.
2. R2 should be changed to a 243 Ω resistor when the FULLSCALE bit (FULL) is set to 1 (Register 18, bit 7).
3. Receive full scale level will produce –0.9 dBFS at SDO.
4. DR = 20 x log |Vin| + 20 x log (RMS signal/RMS noise).
5. Measurement is 300 to 3400 Hz. Applies to both transmit and receive paths.
6. Vin = 1 kHz, –3 dBFS, Fs = 10300 Hz.
7. Vin = 1 KHz, –6 dBFS, Fs = 10300 Hz.
8. THD = 20 x log (RMS distortion/RMS signal).
9. The AOUT pin is an optional pin located on the integrated system-side module. VD refers to the digital power supply of
the integrated system-side module.
Table 5. Absolute Maximum Ratings
Parameter
Symbol
Value
Unit
Operating Temperature Range
TA
–40 to 100
°C
Storage Temperature Range
TSTG
–65 to 150
°C
Note: Permanent device damage may occur if the absolute maximum ratings are exceeded. Functional operation should be
restricted to the conditions as specified in the operational sections of this data sheet. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
Table 6. Digital FIR Filter Characteristics—Transmit and Receive
(Sample Rate = 8 kHz, TA = 70 °C for K-Grade and –40 to 85 °C for B-Grade)
Parameter
Symbol
Min
Typ
Passband (0.1 dB)
Passband (3 dB)
Passband Ripple Peak-to-Peak
F(0.1 dB)
0
—
F(3 dB)
0
—
–0.1
—
Stopband
—
4.4
Stopband Attenuation
–74
—
Group Delay
tgd
—
12/Fs
Note: Typical FIR filter characteristics for Fs = 8000 Hz are shown in Figures 2, 3, 4, and 5.
Max
3.3
3.6
0.1
—
—
—
Unit
kHz
kHz
dB
kHz
dB
sec
Rev. 1.0
7
Share Link: 