LC75852E 데이터 시트보기 (PDF) - SANYO -> Panasonic

부품명

상세내역

제조사

LC75852E

Asynchronous Silicon Gate 1/2 Duty LCD Driver with On-Chip Key Input Function

SANYO -> Panasonic 

LC75852E, 75852W

Internal Block States during the Reset Period (when RES is low)

1. CLOCK GENERATOR

Reset is applied and the basic clock stops. However, the state of the OSC pin (the normal or sleep state) is

determined after the control data S0 and S1 has been sent.

2. COMMON DRIVER, SEGMENT DRIVER & LATCH

Reset is applied and the display is turned off. However, display data can be input to the LATCH.

3. KEY SCAN

Reset is applied and at the same time as the internal states are set to their initial states, the key scan operation is

disabled.

4. KEY BUFFER

Reset is applied and all the key data is set to the low level.

5. CCB INTERFACE, CONTROL REGISTER, SHIFT REGISTER

To allow serial data transfers, reset is not applied to these circuits.

Output Pin States during the Reset Period (when RES is low)

Output pin

State during reset

S1/P1 to S4/P4

L*3

S5 to S43

L

COM1, COM2

L

KS1/S44, KS2/S45

L*3

KS3 to KS5

X*4

KS6

H

DO

H*5

X: don’t care

Note: 3. These output pins are forcibly set to the segment output mode and held low.

4. Immediately following power on, these output pins are undefined until the control data S0 and S1 has been sent.

5. Since this output pin is an open-drain output, a pull-up resistor of between 1 and 10 kΩ is required. This pin is held high during the reset period

even if key data is read.

No. 4828-12/16

Share Link: