ST6232BB1(2003) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

ST6232BB1
(Rev.:2003)

8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, 16-BIT AUTO-RELOAD TIMER, EEPROM, SPI AND UART

STMicroelectronics 

ST62T32B ST62E32B

2 CENTRAL PROCESSING UNIT

2.1 INTRODUCTION

The CPU Core of ST6 devices is independent of the

I/O or Memory configuration. As such, it may be

thought of as an independent central processor

communicating with on-chip I/O, Memory and Pe-

ripherals via internal address, data, and control

buses. In-core communication is arranged as

shown in Figure 7; the controller being externally

linked to both the Reset and Oscillator circuits,

while the core is linked to the dedicated on-chip pe-

ripherals via the serial data bus and indirectly, for

interrupt purposes, through the control registers.

2.2 CPU REGISTERS

The ST6 Family CPU core features six registers and

three pairs of flags available to the programmer.

These are described in the following paragraphs.

Accumulator (A). The accumulator is an 8-bit

general purpose register used in all arithmetic cal-

culations, logical operations, and data manipula-

tions. The accumulator can be addressed in Data

space as a RAM location at address FFh. Thus the

ST6 can manipulate the accumulator just like any

other register in Data space.

Figure 7. ST6 Core Block Diagram

Indirect Registers (X, Y). These two indirect reg-

isters are used as pointers to memory locations in

Data space. They are used in the register-indirect

addressing mode. These registers can be ad-

dressed in the data space as RAM locations at ad-

dresses 80h (X) and 81h (Y). They can also be ac-

cessed with the direct, short direct, or bit direct ad-

dressing modes. Accordingly, the ST6 instruction

set can use the indirect registers as any other reg-

ister of the data space.

Short Direct Registers (V, W). These two regis-

ters are used to save a byte in short direct ad-

dressing mode. They can be addressed in Data

space as RAM locations at addresses 82h (V) and

83h (W). They can also be accessed using the di-

rect and bit direct addressing modes. Thus, the

ST6 instruction set can use the short direct regis-

ters as any other register of the data space.

Program Counter (PC). The program counter is a

12-bit register which contains the address of the

next ROM location to be processed by the core.

This ROM location may be an opcode, an oper-

and, or the address of an operand. The 12-bit

length allows the direct addressing of 4096 bytes

in Program space.

RESET

0,01 TO 8MHz

OSCin

OSCout

CONTROLLER

INTERRUPTS

DATA SPACE

OPCODE

FLAG

VALUES

2

CONTROL

SIGNALS

ADDRESS/READ LINE

DATA

RAM/EEPROM

PROGRAM

ROM/EPROM

12

Program Counter

and

6 LAYER STACK

ADDRESS 256

DECODER

DATA

ROM/EPROM

A-DATA B-DATA

DEDICATIONS

ACCUMULATOR

FLAGS

ALU

RESULTS TO DATA SPACE (WRITE LINE)

VR01811

16/84

Share Link: