T83C5101XXX-3ZSIL 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

T83C5101XXX-3ZSIL

8-bit Low Pin Count Microcontrollers

Atmel Corporation 

Broadcast Address

Reset Addresses

T8xC5101/02

The SADEN byte is selected so that each slave may be addressed separately.

For slave A, bit 0 (the LSB) is a don’t-care bit; for slaves B and C, bit 0 is a 1. To com-

municate with slave A only, the master must send an address where bit 0 is clear (e.g.

1111 0000b).

For slave A, bit 1 is a 1; for slaves B and C, bit 1 is a don’t care bit. To communicate with

slaves B and C, but not slave A, the master must send an address with bits 0 and 1 both

set (e.g. 1111 0011b).

To communicate with slaves A, B and C, the master must send an address with bit 0

set, bit 1 clear, and bit 2 clear (e.g. 1111 0001b).

A broadcast address is formed from the logical OR of the SADDR and SADEN registers

with zeros defined as don’t-care bits, e.g.:

SADDR 0101 0110b

SADEN 1111 1100b

Broadcast =SADDR OR SADEN1111 111Xb

The use of don’t-care bits provides flexibility in defining the broadcast address, however

in most applications, a broadcast address is FFh. The following is an example of using

broadcast addresses:

Slave A:SADDR1111 0001b

SADEN1111 1010b

Broadcast1111 1X11b,

Slave B:SADDR1111 0011b

SADEN1111 1001b

Broadcast1111 1X11B,

Slave C:SADDR=1111 0010b

SADEN1111 1101b

Broadcast1111 1111b

For slaves A and B, bit 2 is a don’t care bit; for slave C, bit 2 is set. To communicate with

all of the slaves, the master must send an address FFh. To communicate with slaves A

and B, but not slave C, the master can send and address FBh.

On reset, the SADDR and SADEN registers are initialized to 00h, i.e. the given and

broadcast addresses are XXXX XXXXb (all don’t-care bits). This ensures that the serial

port will reply to any address, and so, that it is backwards compatible with the 80C51

microcontrollers that do not support automatic address recognition.

21

4233H–8051–02/08

Share Link: