TDA4841 데이터 시트보기 (PDF) - Philips Electronics
부품명
상세내역
제조사
TDA4841 Datasheet PDF : 60 Pages
| |||
Philips Semiconductors
I2C-bus autosync deflection controller for
PC monitors
Product specification
TDA4841PS
SYMBOL
PARAMETER
CONDITIONS
MIN. TYP. MAX. UNIT
THRESHOLDS DERIVED FROM HPLL2 VOLTAGE
VHPLL2(blank)(ul)
upper limit for continuous
blanking
VHPLL2(bduty)(ul)
upper limit for variation of
BDRV duty cycle
VHPLL2(bduty)(ll)
lower limit for variation of BDRV
duty cycle
VHPLL2(hduty)(ul)
upper limit for variation of
HDRV duty cycle
VHPLL2(hduty)(ll)
lower limit for variation of HDRV
duty cycle
VHPLL2(stby)(ll)
lower limit for VOUT1 and
VOUT2 to be active via I2C-bus
soft start
VHPLL2(stby)(ul)
VHPLL2(stby)(ll)
upper limit for standby voltage
lower limit for VOUT1 and
VOUT2 to be active via external
DC current
−
4.6
−
V
−
4.0
−
V
−
3.2
−
V
−
3.2
−
V
−
1.8
−
V
−
1.1
−
V
−
1
−
V
−
0
−
V
Notes
1. For duration of vertical blanking pulse see subheading “Vertical oscillator (oscillator frequency in application without
adjustment of free-running frequency ffr(V))”.
2. Continuous blanking at CLBL (pin 16) will be activated, if one of the following conditions is true:
a) No horizontal flyback pulses at HFLB (pin 1) within a line
b) X-ray protection is triggered
c) Voltage at HPLL2 (pin 30) is low during soft start
d) Supply voltage at VCC (pin 10) is low
e) PLL1 unlocked while frequency-locked loop is in search mode.
3. Oscillator frequency is fmin when no sync input signal is present (no continuous blanking at pins 16 and 17).
4. Loading of HPLL1 (pin 26) is not allowed.
5. Voltage at HPLL1 (pin 26) is fed to HBUF (pin 27) via a buffer. Disturbances caused by horizontal sync are removed
by an internal sample-and-hold circuit.
6. All vertical and EW adjustments according note 8, but VSIZE = 80% (register VSIZE = 63, VGAIN = 63 and control
bit VOVSCN = 0).
7. Value of resistor at VREF (pin 23) may not be changed.
1999 Oct 25
26
Share Link: 