NXP Semiconductors
TEA1532BT; TEA1532CT
GreenChip II SMPS control IC
Table 5. Characteristics …continued
Symbol
Parameter
Conditions
Min
Driver (pin DRIVER)
Isource
source current
VCC = 9.5 V;
-
VDRIVER = 2 V
Isink
sink current
VCC = 9.5 V
VDRIVER = 2 V
-
VDRIVER = 9.5 V
400
Vo(max)
maximum output
VCC > 12 V
-
voltage
Temperature protection
Tpl(max)
maximum protection
130
level temperature
Tpl(hys)
protection level
VCC > 2 V
-
hysteresis temperature
[1] TEA1532CT: safe restart; TEA1532BT: latch.
[2] Guaranteed by design.
[3] Vi detection level. Set by the demagnetization resistor RDEM; see Section 7.16.
11. Application information
Typ
Max
Unit
−170
−88
mA
300
-
mA
700
-
mA
11.5
12
V
140
150
°C
8
-
°C
A converter with the TEA1532BT; TEA1532CT consists of an input filter, a transformer
with a third winding (auxiliary), and an output stage with a feedback circuit.
Capacitor CVCC buffers the IC supply voltage, which is powered via the internal current
source, that is connected to the rectified mains during start-up and, via the auxiliary
winding, during operation.
A sense resistor Rsense converts the primary current into a voltage at pin SENSE. The
value of Rsense defines the maximum primary peak current.
Figure 9 shows a flyback configuration using the discontinuous conduction mode.
Pin PROTECT is used in this example for external overvoltage protection and open loop
or output short-circuit protection. If this pin is not used, it must be tied to ground. Figure 12
shows a flyback configuration using the continuous conduction mode. The pin PROTECT
is used in this example for external overtemperature protection and open loop or output
short-circuit protection.
TEA1532BT_TEA1532CT_1
Product data sheet
Rev. 01 — 18 January 2007
© NXP B.V. 2007. All rights reserved.
15 of 23