TK14588V/14588 데이터 시트보기 (PDF) - Toko America Inc
부품명
상세내역
제조사
TK14588V/14588 Datasheet PDF : 20 Pages
| |||
TK14588
CIRCUIT DESCRIPTION (CONT.)
FM Detector:
The FM detector is included in the quadrature FM detector using a Gilbert multiplier.
It is suitable for high speed data communication because the demodulation bandwidth is over 1 MHz.
The phase shifter is connected between Pin 14 (IF limiter output) and Pin 13 (input detector). Any available phase shifter
can be used: a LC resonance circuit, a ceramic discriminator, a delay line, etc.
Figure 4 shows the internal equivalent circuit of the detector.
VCC
VCC
QA
VCC
QB
multiplier core circuit
FIGURE 4
The signal from the phase shifter is applied to the multiplier (in the dotted line) through emitter-follower stage QA. When
the phase shifter is connected between Pin 14 and Pin 13, note that the bias voltage to Pin 13 should be provided from
an external source because Pin 13 is only connected to the base of QA.
Because the base of QB (at the opposite side) is connected with the supply voltage, Pin 13 has to be biased with the
equivalent voltage.
Using an LC resonance circuit is not a problem (see Figure 5). However, when using a ceramic discriminator, it is necessary
to pay attention to bias. If there is a difference of the base voltages, the DC voltages of the multiplier do not balance. It
alters the DC zero point or worsens the distortion of demodulation output.
The Pin 13 input level should be saturated at the multiplier; if this level is lower, it is easy to disperse the modulation output.
Therefore, to have stable operation, Pin 13 should be higher than 100 mVP-P.
The following figures show examples of the phase shifter.
Rz is the characteristic impedance
VCC
VCC
VCC
Rz
Rz
Delay
Line
LC resonance circuit
ceramic discriminator
delay line
January 2000 TOKO, Inc.
FIGURE 5 - EXAMPLES OF PHASE SHIFTER
Page 15
Share Link: 