W25X10L 데이터 시트보기 (PDF) - Winbond

부품명

상세내역

제조사

W25X10L

1M-BIT, 2M-BIT, 4M-BIT AND 8M-BIT 2.5V SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

Winbond 

W25X10L, W25X20L, W25X40L, W25X80L

9.2.5 Read Status Register (05h)

The Read Status Register instruction allows the 8-bit Status Register to be read. The instruction is

entered by driving /CS low and shifting the instruction code “05h” into the DIO pin on the rising edge of

CLK. The status register bits are then shifted out on the DO pin at the falling edge of CLK with most

significant bit (MSB) first as shown in figure 6. The Status Register bits are shown in figure 3 and

include the BUSY, WEL, BP2-BP0, TB and SRP bits (see description of the Status Register earlier in

this data sheet).

The Status Register instruction may be used at any time, even while a Program, Erase or Write Status

Register cycle is in progress. This allows the BUSY status bit to be checked to determine when the

cycle is complete and if the device can accept another instruction. The Status Register can be read

continuously, as shown in Figure 6. The instruction is completed by driving /CS high.

Figure 6. Read Status Register Instruction Sequence Diagram

- 17 -

Publication Release Date: February 27, 2008

Revision I

Share Link: