EVM-900-DT 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

제조사

EVM-900-DT

HumDT™ Series RF Transceiver Module

Unspecified 

Delete Associated Module - Command Code = 3B

This command removes the association between the current module and

another module.

Delete Associated Module Command and Response

Command

Start Command Param 1 Param 2 Param 3 Param 4

End

3C

3B

SrcAdr3 SrcAdr2 SrcAdr1 SrcAdr0

3E

Response

Start Response Param 1

End

3C

3B

Status

3E

Figure 49: Delete Associated Module Command and Response

Associated modules can only be removed one by one using this command.

Once a module is deleted, the AP cannot communicate with the ED until

a new link is established and the modules become associated again.

This requires a power cycle or a reset on the ED. The parameters of this

command contain the address of the module to be deleted, where SrcAdr3

is the MSB and SrcAdr0 is the LSB.

The response parameter indicates if the command was successful (00) or if

there was an error (01).

Reset Module - Command Code = 3C

This command initiates a full module reset.

Reset Module Command and Response

Command

Start Command End

3C

3C

3E

Response

Start Response Param 1

End

3C

3C

Status

3E

Figure 50: Reset Module Command and Response

This serial command is the equivalent of pulling the RESET line low.

– 46 –

– 47 –

Share Link: