5.3 General device configuration
This section of the configuration word handles RF and device related parameters
modes:
RX2_EN CM RFDR_SB
XO_F
15
14
13
12
11
10
RF_PWR
9
8
Bit 15:
Table 7 RF operational settings
RX2_EN:
Logic 0: One channel receive
Logic 1: Two channels receive
NOTE
In two channels receive, the TRW-24G receives on two, separate frequency channels
simultaneously. The frequency of receive channel 1 is set in the configurati on word
B[7-1], receive channel 2 is always 8 channels (8 MHz) above receive channel 1.
Bit 14:
Communication Mode:
Logic 1: operates in ShockBurstTM mode
Bit 13:
RF Data Rate:
Logic 0: 250 kbps
Logic 1: 1 Mbps
NOTE
Utilizing 250 kbps instead of 1 Mbps will improve the receiver sensitivity by 10 dB. 1
Mbps requires 16MHz crystal.
Bit 12-10:
XO_F: Selects the crystal frequency to be used. Default to be 16MHz.
XO FREQUENCY SELECTION
D12
D11
D10
MHz
0
0
0
4
0
0
1
8
0
1
0
12
0
1
1
16
1
0
0
20
Table 8 Crystal frequency setting
Bit 9-8:
RF_PWR: Sets TRW-24G RF output power in transmit mode:
http://www.wenshing.com.tw ; http://www.rf.net.tw
TRW-24G Datasheet P.12