AS3932 데이터 시트보기 (PDF) - austriamicrosystems AG

부품명

상세내역

제조사

AS3932

3D Low Frequency Wakeup Receiver

austriamicrosystems AG 

AS3932

Data Sheet - Detailed Description

If the preamble is detected correctly the correlator keeps searching for a data pattern. The duration of the preamble plus the pattern should not

be longer than 40 bits (see bit rate definition in Table 18). The data pattern can be defined by the user and consists of two bytes which are stored

in the registers R5<7:0> and R6<7:0>. The two bytes define the pattern consisting of 16 half bit periods. This means the pattern and the bit

period can be selected by the user. The only limitation is that the pattern (in combination with preamble) must obey Manchester coding and

timing. It must be noted that according to Manchester coding a down-to-up bit transition represents a symbol "0", while a transition up-to-down

represents a symbol "1". If the default code is used (96 [hex]) the binary code is (10 01 01 10 01 10 10 01). MSB has to be transmitted first.

The user can also select (R1<2>) if single or double data pattern is used for wake-up. In case double pattern detection is set, the same pattern

has to be repeated 2 times.

Additionally it is possible to set the number of allowed missing zero bits (not symbols) in the received bitstream (R2<6:5>), as shown in the Table

19.

Table 19. Allowed Pattern Detection Errors

R2<6>

R2<5>

Maximum allowed error in the pattern detection

0

0

No error allowed

0

1

1 missed zero

1

0

2 missed zeros

1

1

3 missed zeros

If the pattern is matched the wake-up interrupt is displayed on the WAKE output. In case the Manchester decoder is enabled (R1<3>) the data

coming out from the DAT pin are decoded and the clock is recovered on the pin DAT_CL.

The data coming out from the DAT pin are stable (and therefore can be acquired) on the rising edge of the CL_DAT clock, as shown in Figure 17.

Figure 17. Synchronization of Data with Recovered Manchester Clock

C L_ DA T

D AT

If the pattern detection fails the internal wake-up (on all active channels) is terminated with no signal sent to MCU and the false wakeup register

will be incremented (R13<7:0>).

8.7 Wakeup Protocol - Carrier Frequency 125 kHz

The wake-up state is terminated with the direct command ‘clear_wake’ Table 12. This command terminates the MCU activity. The termination

can also be automatic in case there is no response from MCU. The time out for automatic termination is set in a register R7<7:5>, as shown in

the Table 20.

Table 20. Timeout Setup

R7<7>

R7<6>

R7<5>

Time out

0

0

0

0 sec

0

0

1

50 msec

0

1

0

100 msec

0

1

1

150 msec

1

0

0

200 msec

1

0

1

250 msec

www.austriamicrosystems.com/AS3932

Revision 1.2

22 - 33

Share Link: