ATMEGA32(2008) 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

ATMEGA32
(Rev.:2008)

8-bit Microcontroller with 32K Bytes In-System Programmable Flash

Atmel Corporation 

Errata

ATmega32, rev. A

to F

• First Analog Comparator conversion may be delayed

• Interrupts may be lost when writing the timer registers in the asynchronous timer

• IDCODE masks data from TDI input

• Reading EEPROM by using ST or STS to set EERE bit triggers unexpected interrupt request.

1. First Analog Comparator conversion may be delayed

If the device is powered by a slow rising VCC, the first Analog Comparator conversion will

take longer than expected on some devices.

Problem Fix/Workaround

When the device has been powered or reset, disable then enable theAnalog Comparator

before the first conversion.

2. Interrupts may be lost when writing the timer registers in the asynchronous timer

If one of the timer registers which is synchronized to the asynchronous timer2 clock is writ-

ten in the cycle before a overflow interrupt occurs, the interrupt may be lost.

Problem Fix/Workaround

Always check that the Timer2 Timer/Counter register, TCNT2, does not have the value 0xFF

before writing the Timer2 Control Register, TCCR2, or Output Compare Register, OCR2

3. IDCODE masks data from TDI input

The JTAG instruction IDCODE is not working correctly. Data to succeeding devices are

replaced by all-ones during Update-DR.

Problem Fix / Workaround

– If ATmega32 is the only device in the scan chain, the problem is not visible.

– Select the Device ID Register of the ATmega32 by issuing the IDCODE instruction or

by entering the Test-Logic-Reset state of the TAP controller to read out the contents

of its Device ID Register and possibly data from succeeding devices of the scan

chain. Issue the BYPASS instruction to the ATmega32 while reading the Device ID

Registers of preceding devices of the boundary scan chain.

– If the Device IDs of all devices in the boundary scan chain must be captured

simultaneously, the ATmega32 must be the fist device in the chain.

4. Reading EEPROM by using ST or STS to set EERE bit triggers unexpected interrupt

request.

Reading EEPROM by using the ST or STS command to set the EERE bit in the EECR reg-

ister triggers an unexpected EEPROM interrupt request.

Problem Fix / Workaround

Always use OUT or SBI to set EERE in EECR.

336 ATmega32(L)

2503N–AVR–06/08

Share Link: