A25L16P 데이터 시트보기 (PDF) - AMIC Technology
부품명
상세내역
제조사
A25L16P Datasheet PDF : 38 Pages
| |||
Write Status Register (WRSR)
The Write Status Register (WRSR) instruction allows new
values to be written to the Status Register. Before it can be
accepted, a Write Enable (WREN) instruction must
previously have been executed. After the Write Enable
(WREN) instruction has been decoded and executed, the
device sets the Write Enable Latch (WEL).
The Write Status Register (WRSR) instruction is entered by
driving Chip Select ( S ) Low, followed by the instruction code
and the data byte on Serial Data Input (DIO).
The instruction sequence is shown in Figure 7. The Write
Status Register (WRSR) instruction has no effect on b6, b5,
b1 and b0 of the Status Register. b6 and b5 are always read
as 0.
Chip Select ( S ) must be driven High after the eighth bit of
the data byte has been latched in. If not, the Write Status
Register (WRSR) instruction is not executed. As soon as
Chip Select ( S ) is driven High, the self-timed Write Status
Register cycle (whose duration is tW) is initiated. While the
A25L16P Series
Write Status Register cycle is in progress, the Status
Register may still be read to check the value of the Write In
Progress (WIP) bit. The Write In Progress (WIP) bit is 1
during the self-timed Write Status Register cycle, and is 0
when it is completed. When the cycle is completed, the Write
Enable Latch (WEL) is reset.
The Write Status Register (WRSR) instruction allows the
user to change the values of the Block Protect (BP2, BP1,
BP0) bits, to define the size of the area that is to be treated
as read-only, as defined in Table 1. The Write Status
Register (WRSR) instruction also allows the user to set or
reset the Status Register Write Disable (SRWD) bit in
accordance with the Write Protect ( W ) signal. The Status
Register Write Disable (SRWD) bit and Write Protect ( W )
signal allow the device to be put in the Hardware Protected
Mode (HPM). The Write Status Register (WRSR) instruction
is not executed once the Hardware Protected Mode (HPM) is
entered.
Figure 7. Write Status Register (WRSR) Instruction Sequence
S
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
C
Instruction
Status
Register In
DIO
7654 3210
DO
High Impedance
MSB
PRELIMINARY (April, 2007, Version 0.6)
12
AMIC Technology Corp.
Share Link: 