A25L16PUQ-UF 데이터 시트보기 (PDF) - AMIC Technology

부품명

상세내역

제조사

A25L16PUQ-UF

16 Mbit, Low Voltage, Serial Flash Memory With 85MHz SPI Bus Interface

AMIC Technology 

Bulk Erase (BE)

The Bulk Erase (BE) instruction sets all bits to 1 (FFh).

Before it can be accepted, a Write Enable (WREN)

instruction must previously have been executed. After the

Write Enable (WREN) instruction has been decoded, the

device sets the Write Enable Latch (WEL).

The Bulk Erase (BE) instruction is entered by driving Chip

Select ( S ) Low, followed by the instruction code on Serial

Data Input (DIO). Chip Select ( S ) must be driven Low for the

entire duration of the sequence.

The instruction sequence is shown in Figure 14. Chip Select

( S ) must be driven High after the eighth bit of the instruction

code has been latched in, otherwise the Bulk Erase

Figure 14. Bulk Erase (BE) Instruction Sequence

A25L16P Series

instruction is not executed. As soon as Chip Select ( S ) is

driven High, the self-timed Bulk Erase cycle (whose duration

is tBE) is initiated. While the Bulk Erase cycle is in progress,

the Status Register may be read to check the value of the

Write In Progress (WIP) bit. The Write In Progress (WIP) bit

is 1 during the self-timed Bulk Erase cycle, and is 0 when it is

completed. At some unspecified time before the cycle is

completed, the Write Enable Latch (WEL) bit is reset.

The Bulk Erase (BE) instruction is executed only if all

Block Protect (BP2, BP1, BP0) bits are 0. The Bulk Erase

(BE) instruction is ignored if one, or more, sectors are

protected.

S

01 2 3 45 6 7

C

Instruction

DIO

or

Notes: Address bits A23 to A21 are Don’t Care.

PRELIMINARY (April, 2007, Version 0.6)

20

AMIC Technology Corp.

Share Link: