Previous Datasheet
Index
Next Data Sheet
IRSF3011
Switching ElectricalCharacteristics
(VCC = 14V, Resistive Load (RL) = 5Ω, TC= 25°C.) Please refer to Figure 15 for switching time definitions.
Minimum Typical Maximum Units Test Conditions
tdon
Turn-On Delay Time
tr
Rise Time
tdoff
Turn-Off Delay Time
tf
Fall Time
160 250
Vin = 5V
90
Vin = 10V
650 1200
Vin = 5V
250
nS Vin = 10V
250 350
Vin = 5V
300
Vin = 10V
180 350
Vin = 5V
170
Vin = 10V
Protection Characteristics
(TC= 25 °C unless otherwise specified.)
Ids(sd)
Tj(sd)
Vprotect
tIresp
tIblank
Ipeak
Vreset
treset
tTresp
Over-Current Shutdown Threshold
Over Temperature Shutdown Threshold
Min. Input Voltage for Over-temp function
Over Current Response Time
Over Current Blanking Time
Peak Short Circuit Current
Protection Reset Voltage
Protection Reset Time
Over-Temperature Response Time
Minimum Typical Maximum Units
5
7
10 A
155 165 °C
3
V
4
µS
4
16
A
1.3
V
8
µS
12
Test Conditions
Vin = 5V
Vin = 5V, Ids = 2A
See Figure 16 for definition
See Figure 16 for definition
See Figure 16 for definition
See Figure 17 for definition
See Figure 18 for definition
Temperature Coefficients of Electrical Characteristics
(Please see Figures 3 through 14 for more data on thermal characteristics of other electrical parameters.
Vds,clamp
Vth
Vin,clamp
Ids(sd)
Drain-to-Source Clamp Voltage T.C.
Input Threshold Voltage T.C.
Input Clamp Voltage T.C.
Over-Current Shutdown Threshold T.C.
Minimum Typical Maximum Units Test Conditions
18.2
Ids = 10mA
-2.7
mV/°C Vds = 5V, Ids = 10mA
7.0
Iin = 10mA
-9.8
mA/°C Vin = 5V
Notes:
x When mounted on a 1" square PCB (FR-4 or G10 material). For recommended footprint and soldering techniques, refer
to International Rectifier Application Note AN-994.
y EAS is tested with a constant current source of 6A applied for 700µS with Vin = 0V and starting Tj = 25°C.
z Input current must be limited to less than 5mA with a 1kΩ resistor in series with the input when the Body-Drain Diode
is forward biased.
To Order
3