DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

BR24T32-W(2015) 데이터 시트보기 (PDF) - ROHM Semiconductor

부품명
상세내역
제조사
BR24T32-W
(Rev.:2015)
ROHM
ROHM Semiconductor ROHM
BR24T32-W Datasheet PDF : 37 Pages
First Prev 21 22 23 24 25 26 27 28 29 30 Next Last
BR24T32-W
Datasheet
Power-Up / Down Conditions
At power ON, the IC’s internal circuits may go through unstable low voltage area as the Vcc rises, making the IC’s internal
logic circuit not completely reset, hence, malfunction may occur. To prevent this, the IC is equipped with POR circuit and
LVCC circuit. To assure the operation, observe the following conditions at power ON.
1. Set SDA = 'H' and SCL ='L' or 'H’
2. Start power source so as to satisfy the recommended conditions of tR, tOFF, and Vbot for operating POR circuit.
tR
VCC
Recommended conditions of tR, tOFF,Vbot
tR
tOFF
Vbot
tOFF
Vbot
0
Figure 51. Rise Waveform Diagram
10ms or below
100ms or below
10ms or larger
10ms or larger
0.3V or below
0.2V or below
3. Set SDA and SCL so as not to become 'Hi-Z'.
When the above conditions 1 and 2 cannot be observed, take the following countermeasures.
(1) In the case when the above condition 1 cannot be observed such that SDA becomes 'L' at power ON.
Control SCL and SDA as shown below, to make SCL and SDA, 'H' and 'H'.
VCC
SCL
tLOW
SDA
After Vcc becomes stable
tDH
tSU:DAT
Figure 52. When SCL= 'H' and SDA= 'L'
After Vcc becomes stable
tSU:DAT
Figure 53. When SCL='L' and SDA='L'
(2) In the case when the above condition 2 cannot be observed.
After power source becomes stable, execute software reset (Page 18).
(3) In the case when the above conditions 1 and 2 cannot be observed.
Carry out (1), and then carry out (2).
Low Voltage Malfunction Prevention Function
LVCC circuit prevents data rewrite operation at low power, and prevents write error. At LVCC voltage (Typ =1.2V) or below,
data rewrite is prevented.
Noise Countermeasures
1. Bypass Capacitor
When noise or surge gets in the power source line, malfunction may occur, therefore, it is recommended to connect a
bypass capacitor (0.1µF) between IC Vcc and GND pins. Connect the capacitor as close to IC as possible. In addition, it
is also recommended to connect a bypass capacitor between board’s Vcc and GND.
www.rohm.com
©2013 ROHM Co., Ltd. All rights reserved.
TSZ2211115001
21/33
TSZ02201-0R2R0G100060-1-2
03.Feb.2015 Rev.004

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]