DS12887 데이터 시트보기 (PDF) - Dallas Semiconductor -> Maxim Integrated

부품명

상세내역

제조사

DS12887

Real Time Clock

Dallas Semiconductor -> Maxim Integrated 

DS12887

generator, and 114 bytes of nonvolatile static RAM. The real time clock is distinctive in that time–of–day

and memory are maintained even in the absence of power.

OPERATION

The block diagram in Figure 1 shows the pin connections with the major internal functions of the

DS12887. The following paragraphs describe the function of each pin.

BLOCK DIAGRAM DS12887 Figure 1

POWER–DOWN/POWER–UP CONSIDERATIONS

The Real Time Clock function will continue to operate and all of the RAM, time, calendar, and alarm

memory locations remain nonvolatile regardless of the level of the VCC input. When VCC is applied to the

DS12887 and reaches a level of greater than 4.25 volts, the device becomes accessible after 200 ms,

provided that the oscillator is running and the oscillator countdown chain is not in reset (see Register A).

This time period allows the system to stabilize after power is applied. When VCC falls below 4.25 volts,

the chip select input is internally forced to an inactive level regardless of the value of CS at the input pin.

The DS12887 is, therefore, write–protected. When the DS12887 is in a write–protected state, all inputs

are ignored and all outputs are in a high impedance state. When VCC falls below a level of approximately

3 volts, the external VCC supply is switched off and an internal lithium energy source supplies power to

the Real Time Clock and the RAM memory.

SIGNAL DESCRIPTIONS

GND, VCC – DC power is provided to the device on these pins. VCC is the +5 volt input. When 5 volts are

applied within normal limits, the device is fully accessible and data can be written and read. When VCC is

below 4.25 volts typical, reads and writes are inhibited. However, the timekeeping function continues

2 of 19

Share Link: