APW7047KC-TU 데이터 시트보기 (PDF) - Anpec Electronics

부품명

상세내역

제조사

APW7047KC-TU

Dual Advanced PWM and Source-Sink Linear Controller

Anpec Electronics 

APW7047

Electrical Characteristics (Cont.)

Unless otherwise specified, these specifications apply over VCC=VBOOT=12V and TA=0~70°C.

Typical values refer to TA=25°C.

Symbol

Parameter

Test Conditions

IVIN VIN Input Bias Current

PWM Controllers Gate Drivers

VIN=2.5V

IUGATE

UGATE1,2 Source, LGATE1 Source VCC=12V

VUGATE1,2=6V

RGATE UGATE1,2 Sink, LGATE1 Sink

VCC=12V,VUGATE1,2=6V

Protection

VSEN1,2 OVP trip point

(VSEN1/VCORE and VSEN2/VMEM )

VSEN Rising

VSEN1,2 O.V. Hysteresis

IOCSET Ocset Current Source

ISS Soft start Current

Vocset=3V

APW7047

Min. Typ. Max.

2

0.74

3

4

115 120

2

170 200 230

28

Unit

uA

A

Ω

%

uA

Functional Pin Description

VCC (Pin 1)

Provide a +12V bias supply for the IC to this pin. This

pin also provides the gate bias charge for the

MOSFETs of the SOURCE-SINK regulator. The volt-

age at this pin is monitored for Power-On Reset (POR)

purposes.

UGATE1 (Pin 2)

Connect this pin to the upper MOSFET gate of the

PWM1 converter. This pin provides the gate drive for

the MOSFET.

sets the soft-start interval of all power controls and

preventing the outputs from overshoot as well as limit-

ing the input current .

SD (Pin 5)

The pin shuts down all power outputs. A TTL compat-

ible , logic level high signal applied at this pin immedi-

ately discharges the soft-start capacitor,disabling all

power outputs. When re-enabled, the IC undergoes a

new soft-start cycle. Left open, this pin is pulled low

by an internal pull-down resistor, enabling operation.

PHASE1 (Pin 3)

Connect this pin to the PWM1 converter’s upper

MOSFET source.This pin is used to monitor the volt-

age drop across the MOSFET for over-current

protection.

SS (Pin 4)

Connect a capacitor from this pin to ground.This

capacitor, along with an internal 28uA current source,

SOURCE (Pin 6)

Connect this pin to the upper MOSFET gate drive of

the SOURCE-SINK regulator. This pin drives the up-

per external MOSFET as a sourcing regulator.

SINK (Pin 7)

Connect this pin to the lower MOSFET gate drive of

Copyright  ANPEC Electronics Corp. Rev. A.

4

Rev.A.1 - May., 2002

www.anpec.com.tw

Share Link: