EVAL-ADCMP608BKSZ 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

EVAL-ADCMP608BKSZ

Rail-to-Rail, Fast, Low Power 2.5 V to 5.5 V, Single-Supply TTL/CMOS Comparator

Analog Devices 

ADCMP608

INPUT VOLTAGE

500mV OVERDRIVE

10mV OVERDRIVE

VN ± VOS

DISPERSION

Q OUTPUT

Figure 10. Propagation Delay—Overdrive Dispersion

INPUT VOLTAGE

1V/ns

10V/ns

VN ± VOS

DISPERSION

Q OUTPUT

Figure 11. Propagation Delay—Slew Rate Dispersion

Data Sheet

CROSSOVER BIAS POINT

Rail-to-rail inputs of this type, in both op amps and comparators,

have a dual front-end design. Certain devices are active near the

VCC rail and others are active near the VEE rail. At some

predetermined point in the common-mode range, a crossover

occurs. At this point, normally VCC/2, the direction of the bias

current reverses and there are changes in measured offset

voltages and currents.

The ADCMP608 slightly elaborates on this scheme. Crossover

points can be found at approximately 0.8 V and 1.6 V.

MINIMUM INPUT SLEW RATE REQUIREMENT

With the rated load capacitance and normal good PC board

design practice, as discussed in the Optimizing Performance

section, these comparators should be stable at any input slew

rate with no hysteresis. Broadband noise from the input stage is

observed in place of the violent chattering seen with most other

high speed comparators. With additional capacitive loading or

poor bypassing, oscillation may be encountered. These oscillations

are due to the high gain bandwidth of the comparator in

combination with feedback through parasitics in the package

and PC board. In many applications, chattering is not harmful.

Rev. B | Page 8 of 10

Share Link: