ICS662M-03LFT 데이터 시트보기 (PDF) - Integrated Device Technology
부품명
상세내역
제조사
ICS662M-03LFT Datasheet PDF : 7 Pages
| |||
ICS662-03
HDTV AUDIO/VIDEO CLOCK SOURCE
CLOCK SYNTHESIZER
Application Information
Series Termination Resistor
Clock output traces should use series termination. To series
terminate a 50Ω trace (a commonly used trace impedance),
place a 33Ω resistor in series with the clock line, as close to
the clock output pin as possible. The nominal impedance of
the clock output is 20Ω.
Decoupling Capacitors
As with any high performance mixed-signal IC, the
ICS662-03 must be isolated from system power supply
noise to perform optimally.
Decoupling capacitors of 0.01µF must be connected
between VDD (pin 2) and the PCB ground plane (pin 3).
PCB Layout Recommendations
For optimum device performance and lowest output phase
noise, the following guidelines should be observed.
the component side of the board as close to the VDD pin as
possible. No vias should be used between decoupling
capacitor and VDD pin. The PCB trace to VDD pin should
be kept as short as possible, as should the PCB trace to the
ground via. Distance of the ferrite bead and bulk decoupling
from the device is less critical.
2) To minimize EMI and obtain the best signal integrity, the
33Ω series termination resistor should be placed close to
the clock output.
3) An optimum layout is one with all components on the
same side of the board, minimizing vias through other signal
layers (the ferrite bead and bulk decoupling capacitor can be
mounted on the back). Other signal traces should be routed
away from the ICS662-03. This includes signal traces just
underneath the device, or on layers adjacent to the ground
plane layer used by the device.
1) Each 0.01µF decoupling capacitor should be mounted on
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the ICS662-03. These ratings, which are
standard values for ICS commercially rated parts, are stress ratings only. Functional operation of the device at
these or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Item
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Rating
5.5 V
-0.5 V to VDD+0.5 V
0 to +70° C
-65 to +150° C
125° C
260° C
Recommended Operation Conditions
Parameter
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
Min.
0
+3.0
Typ.
Max.
+70
+3.6
Units
°C
V
IDT™ / ICS™ HDTV AUDIO/VIDEO CLOCK SOURCE
3
ICS662-03 REV E 101807
Share Link: 