LM2575-5.0WU 데이터 시트보기 (PDF) - Micrel
부품명
상세내역
제조사
LM2575-5.0WU Datasheet PDF : 9 Pages
| |||
LM2575
Micrel, Inc.
LM2575
Units
Symbol Parameter
Conditions
Typ
Limit
(Note 2)
(Limits)
ON/OFF CONTROL, FIXED and ADJUSTABLE REGULATORS Test Circuit Figure 1
VIH
ON/OFF Pin Logic
VOUT = 0V
VIL
Input Level
VOUT = 5V
IIH
ON /OFF Pin Logic
ON /OFF Pin = 5V (OFF)
Current
1.4
2.2/2.4
1.2
1.0/0.8
4
30
V(min)
V(max)
µA
µA(max)
IIL
ON/OFF Pin = 0V (ON)
0.01
µA
10
µA(max)
Note 1:
Note 2:
Note 3:
Note 4:
Note 5:
Note 6:
Note 7:
Note 8:
Note 9:
Absolute Maximum Rating indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device
is intended to be functional, but do not guarantee specific performance limits. For guaranteed specifications and test conditions, see the Electrical
Characteristics.
All limits guaranteed at room temperature (standard type face) and at temperature extremes (bold type face) . All room temperature limits are
100% production tested. All limits at temperature extreme are guaranteed via testing.
External components such as the catch diode, inductor, input and output capacitors can affect switching regulator system performance. When the
LM2575/LM1575 is used as shown in Figure 1 test circuit, system performance will be shown in system parameters section of Electrical
Characteristics.
Output (pin 2) sourcing current. No diode, inductor or capacitor connected to output.
Feedback (pin 4) removed from output and connected to 0V.
Feedback (pin 4) removed from output and connected to 12V to force the output transistor OFF.
Junction to ambient thermal resistance (no external heat sink) for the 5-lead TO-220 package mounted vertically, with 1/2" leads in a socket, or
on PC board with minimum copper area.
Junction to ambient thermal resistance (no external heat sink) for the 5-lead TO-220 package mounted vertically, with 1/4" leads soldered to PC
board containing approximately 4 square inches of copper area surrounding the leads.
Junction to ambient thermal resistance with approximately 1 square inch of pc board copper surrounding the leads. Additional copper will lower
thermal resistance further.
Typical Performance Characteristics
Normalized
Feedback Voltage*
25
20
VIN = 12V
15
10
ILOAD = 200mA
Normalized to TJ = 25˚C
5
0
-5
-10
-15
-20
-25
-75 -50 -25 0 25 50 75 100 125 150
JUNCTION TEMPERATURE (˚C)
* Adjustable version only
Feedback Voltage
vs Duty Cycle*
20
15
ILOAD = 200 mA
10
5
VIN = 40V
0
-5
-10
VIN = 7V
-15
-20
0
20 40 60 80 100
DUTY CYCLE (%)
April 2005
5
M9999-042205
Share Link: 