MAX1072ETC-T 데이터 시트보기 (PDF) - Maxim Integrated
부품명
상세내역
제조사
MAX1072ETC-T Datasheet PDF : 18 Pages
| |||
1.8Msps, Single-Supply, Low-Power,
True-Differential, 10-Bit ADCs
ABSOLUTE MAXIMUM RATINGS
VDD to GND ..............................................................-0.3V to +6V
VL to GND ...................-0.3V to the lower of (VDD + 0.3V) or +6V
Digital Inputs
to GND ....................-0.3V to the lower of (VDD + 0.3V) or +6V
Digital Output
to GND .......................-0.3V to the lower of (VL + 0.3V) or +6V
Analog Inputs and
REF to GND.............-0.3V to the lower of (VDD + 0.3V) or +6V
RGND to GND .......................................................-0.3V to +0.3V
Maximum Current into Any Pin............................................50mA
Continuous Power Dissipation (TA = +70°C)
12-Pin TQFN (derate 16.9mW/°C above +70°C) ......1349mW
Operating Temperature Range
MAX107_ ETC.................................................-40°C to +85°C
Junction Temperature ......................................................+150°C
Storage Temperature Range .............................-60°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(VDD = +5V ±5%, VL = VDD, VREF = 4.096V, fSCLK = 28.8MHz, 50% duty cycle, TA = -40°C to +85°C, unless otherwise noted. Typical
values are at TA = +25°C.)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
DC ACCURACY
Resolution
10
Bits
Relative Accuracy
INL (Note 1)
±0.5 LSB
Differential Nonlinearity
DNL (Note 2)
±0.5 LSB
Offset Error
±2
LSB
Offset-Error Temperature
Coefficient
±1
ppm/°C
Gain Error
Offset nulled
±2
LSB
Gain Temperature Coefficient
±2
ppm/°C
DYNAMIC SPECIFICATIONS (fIN = 525kHz sine wave, VIN = VREF, unless otherwise noted.)
Signal-to-Noise Plus Distortion
SINAD
60
61
dB
Total Harmonic Distortion
THD
-80
-74
dB
Spurious-Free Dynamic Range
SFDR
-80
-74
dB
Intermodulation Distortion
Full-Power Bandwidth
IMD
fIN1 = 250kHz, fIN2 = 300kHz
-3dB point, small-signal method
-78
dB
20
MHz
Full-Linear Bandwidth
S/(N + D) > 56dB, single ended
2
MHz
CONVERSION RATE
Minimum Conversion Time
Maximum Throughput Rate
tCONV (Note 3)
0.556 μs
1.8
Msps
Minimum Throughput Rate
(Note 4)
10
ksps
Track-and-Hold Acquisition Time
Aperture Delay
tACQ
(Note 5)
104
ns
5
ns
Aperture Jitter
(Note 6)
30
ps
External Clock Frequency
fSCLK
28.8 MHz
2 _______________________________________________________________________________________
Share Link: 