DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MAX17079 데이터 시트보기 (PDF) - Maxim Integrated

부품명
상세내역
제조사
MAX17079 Datasheet PDF : 12 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
4-Level or 2-Level Logic to High-Voltage
Level Shifter for TFT LCD TV Display
Pin Description (continued)
PIN
NAME
FUNCTION
39
EN
Enable Input. All outputs connect to VCOM when EN is low.
Select Input for Two Level/Four Level. Connect CH to VCC for two-level operation and tie CH to
40
CH
DGND or leave it unconnected for four-level operation. For two-level operation, power VH2 and VL2
and control the outputs with Ax inputs. Bx inputs can be left unconnected or be connected to AGND.
EP
Exposed Pad. Connect the exposed backside pad to AGND and DGND.
Detailed Description
The MAX17079 is a 7-channel level shifter that converts
a 2-bit logic-level input to a five-level high-voltage out-
put. The outputs are connected to the four output rails
(VH1, VH2, VL1, VL2) through 3Ω switches and to the
fifth rail (VCOM) through a 15Ω switch. The output rails
lie between DGND and the upper supply rail (VLS).
The MAX17079 has two modes of operation. When
ST = VCC, it operates in sequential mode and when ST
= AGND, it operates in combinational mode. The
MAX17079 can operate in either two-level output or
four-level output configuration. In four-level output
mode, the output can connect to VH1, VH2, VL2, or VL1,
and in two-level output mode, the output can connect to
VH2 or VL2. Connect CH to AGND for four-level opera-
tion and connect CH to VCC for two-level operation.
The output supply rail voltages should satisfy the fol-
lowing condition at all times:
VLS VH1 (VH2, VL2, VCOM) VL1
The MAX17079 has built-in dead time to avoid shoot-
through current. The propagation delay between input
and output is 80ns and the rise time is 30ns.
Figure 1 is the MAX17079 typical operating circuit and
Figure 2 shows the functional diagram.
Four-Level Combinational Logic
Connect CH and ST to AGND for four-level combina-
tional operation. If EN is LOW or VCC is less than UVLO
or VLS is less than its UVLO, the outputs are in STAND-
BY and the outputs connect to VCOM. After EN is HIGH
or VCC is greater than UVLO and VLS is greater than
its UVLO, the outputs are ready to respond to logic
inputs at Ax, Bx. If EN goes HIGH after a rising or
falling edge of Ax or Bx, the device remains in STAND-
BY state until the next edge comes. All state transitions
can be level triggered. The output is determined by the
following truth table (Table 1).
Table 1. Truth Table Four-Level
Combinational Operation
HIGH (Bx)
HIGH (Ax)
OAx = VH1
OBx = VL1
LOW (Ax)
OAx = VL1
OBx = VH1
LOW (Bx)
OAx = VH2
OBx = VL2
OAx = VL2
OBx = VH2
_______________________________________________________________________________________ 7

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]