NCP5007SNT1 데이터 시트보기 (PDF) - ON Semiconductor

부품명

상세내역

제조사

NCP5007SNT1

Compact Backlight LED Boost Driver

ON Semiconductor 

NCP5007

PIN FUNCTION DESCRIPTION

Pin

Symbol

Type

1

FB

ANALOG

INPUT

2

GND

POWER

3

EN

DIGITAL

INPUT

4

Vout

POWER

5

Vbat

POWER

Description

This pin provides the output current range adjustment by means of a sense resistor connected

to the analog control or with a PWM control. The dimming function can be achieved by applying

a PWM voltage technique to this pin (see Figure 29). The current output tolerance depends

upon the accuracy of this resistor. Using a "5% metal film resistor, or better, yields good output

current accuracy. Note: A built−in comparator switches OFF the DC−DC converter if the voltage

sensed across this pin and ground is higher than 700 mV typical.

This pin is the system ground for the NCP5007 and carries both the power and the analog

signals. High quality ground must be provided to avoid spikes and/or uncontrolled operation.

Care must be observed to avoid high−density current flow in a limited PCB copper track so a

robust ground plane connection is recommended.

This is an Active−High logic input which enables the boost converter. The built−in pulldown

resistor disables the device when the EN pin is left open. Note the logic switching level of this

input has been optimized to allow it to be driven from standard or 1.8 V CMOS logic levels.

The LED brightness can be controlled by applying a pulse width modulated signal to the enable

pin (see Figure 30).

This pin is the power side of the external inductor and must be connected to the external

Schottky diode. It provides the output current to the load. Since the boost converter operates in

a current loop mode, the output voltage can range up to +22 V but shall not exceed this limit.

However, if the voltage on this pin is higher than the OVP threshold (Over Voltage Protection)

the device enters a shutdown mode. To restart the chip, one must either apply a low to high logic

signal to the EN pin, or switch off the Vbat supply.

A capacitor must be used on Vout to avoid false triggering of the OVP (Overvoltage Protect)

circuit. This capacitor filters the noise created by the fast switching transients. In order to limit

the inrush current and still have acceptable startup time the capacitor value should range

between 1.0 mF and 8.2 mF max. To achieve high efficiency this capacitor should be ceramic

(ESR t 100 mW).

Care must be observed to avoid EMI through the PCB copper tracks connected to this pin.

The external voltage supply is connected to this pin. A high quality reservoir capacitor must be

connected across pin 5 and Ground to achieve the specified output voltage parameters. A

4.7 mF/6.3 V, low ESR capacitor must be connected as close as possible across pin 5 and

ground pin 2. The X5R or X7R ceramic MURATA types are recommended.

The return side of the external inductor shall be connected to this pin. Typical application will

use a 22 mH, size 1210, to handle the 10 to 100 mA output current range. When the desired

output current is above 20 mA, the inductor shall have an ESR v1.5 W to achieve good

efficiency over the Vbat range. The output current tolerance can be improved by using a larger

inductor value.

http://onsemi.com

3

Share Link: