MAX4838EXT-T 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

MAX4838EXT-T

Overvoltage Protection Controllers with Status FLAG

Maxim Integrated 

Overvoltage Protection Controllers with

Status FLAG

VIN < UVLO

STANDBY

GATE = 0

FLAG = LOW

VIN > UVLO

TIMER STARTS

COUNTING

t = 50ms

OVLO CHECK

GATE = 0

FLAG = LOW

VIN < OVLO

STARTUP

GATE DRIVEN HIGH

FLAG = LOW

t = 50ms

ON

GATE HIGH

FLAG = HIGH

VIN > OVLO

Figure 6. State Diagram

Applications Information

MOSFET Configuration

The MAX4838–MAX4841 can be used with either a sin-

gle MOSFET configuration as shown in the Typical

Operating Circuit, or can be configured with a back-to-

back MOSFET as shown in Figure 7.

The MAX4838–MAX4841 can drive either a single

MOSFET or back-to-back MOSFETs. The back-to-back

configuration has almost zero reverse current when the

input supply is below the output.

If reverse current leakage is not a concern, a single

MOSFET can be used. This approach has half the loss

of the back-to-back configuration when used with simi-

lar MOSFET types, and is a lower cost solution. Note

that if the input is actually pulled low, the output is

pulled low as well due to the parasitic body diode in the

MOSFET. If this is a concern, then the back-to-back

configuration should be used.

INPUT

0 TO 28V

NMOS

OUTPUT

1

4

IN

GATE

VIO

1µF

MAX4838–

MAX4841

6

EN

3

FLAG

2

GND

NOTE: EN AND PULLUP

RESISTOR ON MAX4838/

MAX4840 ONLY.

Figure 7. Back-to-Back External MOSFET Configuration

MOSFET Selection

The MAX4838–MAX4841 are designed for use with

either a single N-channel MOSFET or dual back-to-

back N-channel MOSFETs. In most situations,

MOSFETs with RDS(ON) specified for a VGS of 4.5V

work well. If the input supply is near the UVLO maxi-

mum of 3.5V consider using a MOSFET specified for a

lower VGS voltage. Also the VDS should be 30V for the

MOSFET to withstand the full 28V IN range of the

MAX4838–MAX4841. Table 1 shows a selection of

MOSFETs appropriate for use with the MAX4838–

MAX4841.

IN Bypass Considerations

For most applications, bypass IN to GND with a 1µF

ceramic capacitor. If the power source has significant

inductance due to long lead length, take care to pre-

vent overshoots due to the LC tank circuit and provide

protection if necessary to prevent exceeding the 30V

absolute maximum rating on IN.

The MAX4838–MAX4841 provide protection against volt-

age faults up to 28V, but this does not include negative

voltages. If negative voltages are a concern, connect a

Schottky diode from IN to GND to clamp negative

input voltages.

ESD Test Conditions

ESD performance depends on a number of conditions.

The MAX4838–MAX4841 are specified for 15kV typical

ESD resistance on IN when IN is bypassed to ground

with a 1µF ceramic capacitor. Contact Maxim for a reli-

ability report that documents test setup, methodology,

and results.

_______________________________________________________________________________________ 7

Share Link: