MCP6546 데이터 시트보기 (PDF) - Microchip Technology

부품명

상세내역

제조사

MCP6546

Open-Drain Output Sub-Microamp Comparators

Microchip Technology 

MCP6546/6R/6U/7/8/9

3.0 PIN DESCRIPTIONS

Descriptions of the pins are listed in Table 3-1.

TABLE 3-1: PIN FUNCTION TABLE

MCP6546

(PDIP,

SOIC,

MSOP)

MCP6546

(SOT-23-5,

SC-70-5)

6

1

2

4

3

3

7

5

—

—

—

—

—

—

—

—

—

—

—

—

4

2

—

—

—

—

—

—

—

—

1, 5, 8

—

1

4

1

6

4

1

2

2

3

3

3

3

2

5

8

7

—

—

5

—

—

—

6

—

—

—

7

—

—

—

—

—

—

—

—

—

—

—

—

—

5

2

4

4

—

—

—

—

—

—

—

—

—

—

—

—

—

—

—

8

—

—

— 1, 5

3.1 Analog Inputs

The comparator non-inverting and inverting inputs are

high-impedance CMOS inputs with low bias currents.

3.2 CS Digital Input

This is a CMOS, Schmitt-triggered input that places the

part into a low power mode of operation.

3.3 Digital Outputs

The comparator outputs are CMOS, open-drain digital

outputs. They are designed to make level shifting and

wired-OR easy to implement.

Symbol

Description

1 OUT, OUTA Digital Output (comparator A)

2 VIN–, VINA– Inverting Input (comparator A)

3 VIN+, VINA+ Non-inverting Input (comparator A)

4

VDD

Positive Power Supply

5

VINB+ Non-inverting Input (comparator B)

6

VINB– Inverting Input (comparator B)

7

OUTB Digital Output (comparator B)

8

OUTC Digital Output (comparator C)

9

VINC– Inverting Input (comparator C)

10

VINC+ Non-inverting Input (comparator C)

11

VSS

Negative Power Supply

12

VIND+ Non-inverting Input (comparator D)

13

VIND– Inverting Input (comparator D)

14

OUTD Digital Output (comparator D)

—

CS

Chip Select

—

NC

No Internal Connection

3.4 Power Supply (VSS and VDD)

The positive power supply pin (VDD) is 1.6V to 5.5V

higher than the negative power supply pin (VSS). For

normal operation, the other pins are at voltages

between VSS and VDD, except the output pins which

can be as high as 10V above VSS.

Typically, these parts are used in a single (positive)

supply configuration. In this case, VSS is connected to

ground and VDD is connected to the supply. VDD will

need a local bypass capacitor (typically 0.01 µF to

0.1 µF) within 2 mm of the VDD pin. These can share a

bulk capacitor with nearby analog parts (within

100 mm), but it is not required.

DS21714E-page 12

© 2006 Microchip Technology Inc.

Share Link: