PS22053 데이터 시트보기 (PDF) - Powerex
부품명
상세내역
제조사
PS22053 Datasheet PDF : 10 Pages
| |||
Powerex, Inc., 200 E. Hillis Street, Youngwood, Pennsylvania 15697-1800 (724) 925-7272
PS22053
Intellimod™ Module
Dual-In-Line Intelligent Power Module
10 Amperes/1200 Volts
Absolute Maximum Ratings, Tj = 25°C unless otherwise specified
Characteristics
Symbol
PS22053
Power Device Junction Temperature*
Module Case Operation Temperature (See Note 1)
Storage Temperature
Mounting Torque, M4 Mounting Screws
Tj
-20 to 125
TC
-20 to 100
Tstg
-40 to 125
—
13
Module Weight (Typical)
—
77
Self-protection Supply Voltage Limit (Short Circuit Protection Capability)**
Heatsink Flatness (See Note 2)
VCC(prot.)
800
-50 to 100
Isolation Voltage, AC 1 minute, 60Hz Sinusoidal, Connection Pins to Heatsink Plate
VISO
2500
*The maximum junction temperature rating of the power chips integrated within the DIP-IPM is 150°C (@TC ≤ 100°C). However, to ensure safe operation of the DIP-IPM,
the average junction temperature should be limited to Tj(avg) ≤ 125°C (@TC ≤ 100°C).
**VD = 13.5 ~ 16.5V, Inverter Part, Tj = 125°C, Non-repetitive, Less than 2µs
Units
°C
°C
°C
in-lb
Grams
Volts
µm
Volts
IGBT Inverter Sector
Collector-Emitter Voltage
Collector Current (TC = 25°C)
Peak Collector Current (TC = 25°C, <1ms)
Supply Voltage (Applied between P-NU, NV, NW)
Supply Voltage, Surge (Applied between P-NU, NV, NW)
Collector Dissipation (TC = 25°C, per 1 Chip)
VCES
±IC
±ICP
VCC
VCC(surge)
PC
1200
10
20
900
1000
40
Volts
Amperes
Amperes
Volts
Volts
Watts
Control Sector
Supply Voltage (Applied between VP1-VPC, VN1-VNC)
Supply Voltage (Applied between VUFB-VUFS, VVFB-VVFS, VWFB-VWFS)
Input Voltage (Applied between UP, VP, WP-VPC, UN, VN, WN-VNC)
Fault Output Supply Voltage (Applied between FO-VNC)
Fault Output Current (Sink Current at FO Terminal)
Current Sensing Input Voltage (Applied between CIN-VNC)
VD
20
Volts
VDB
20
Volts
VIN
-0.5 ~ VD+0.5
Volts
VFO
-0.5 ~ VD+0.5
Volts
IFO
1
mA
VSC
-0.5 ~ VD+0.5
Volts
Note 1 – TC Measure Point
CONTROL TERMINALS
POWER TERMINALS
HEATSINK
BOUNDARY
TC POINT
Note 2 – Flatness Measurement Position
+–
MEASUREMENT POINT
3.25mm
HEATSINK
–
+
HEATSINK
2
Rev. 10/05
Share Link: 