DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

PQ30RV21 데이터 시트보기 (PDF) - Sharp Electronics

부품명
상세내역
제조사
PQ30RV21
Sharp
Sharp Electronics Sharp
PQ30RV21 Datasheet PDF : 9 Pages
1 2 3 4 5 6 7 8 9
Low Power-Loss Voltage Regulators
s ON/OFF Operation
D1
VIN
1
2
VO
R2
D2
4
+
CIN
3
VADJ R1
R3
CO
RL
PQ30RV1/PQ30RV11/PQ30RV2/PQ30RV21
VADJ
D2
R2
R1
RL
RD
VO'
High : Output OFF
VC
Low : Output ON
Equivalent Circuit
in OFF-state
q ON/OFF operation is available by mounting externally D2 and R3.
q When VADJ is forcibly raised above Vref(1.25V TYP)by applying the external signal, the output is turned off(pass transistor of
regulator is turned off). When the output is OFF, VADJ must be higher then Vref MAX., and at the same time must be lower
than maximum rating 7V.
In OFF-state, the load current flows to RL from VADJ through R2. Therefore the value of R2 must be as high as possible.
q VO'=VADJRL/(RL+R2)
occurs at the load. OFF-state equivalent circuit R1 up to 10kis allowed. Select as high value of RL and R2 as possible in this
range. In some case, as output voltage is getting lower(VO<1V), impedance of load resistance rises. In such condition, it is
sometime impossible to obtain the minimum value of VO'. So add the dummy resistance indicated by RD in the figure to the
circuit parallel to the load.
s An Example of ON/OFF Circuit Using the 1-chip Microcomputer Output Port(PQ30RV1)
<Specification>
Output port of microcomputer
VOH(max)=0.5 V
VOH(min)=2.4 V (IOH=0.2mA)
MAX. rating of IOH=0.5mA
Output should be set as follows.
15.6V RL=52(IO=0.3A)
From VO=1.25V(1+R2/R1)we get VO=15.6V.
R2/R1=11.48
Assuming that VF(max)=0.8V for D2 in case of VOH(min)=2.4V, we get VADJ=VOH(min)VF(max)=2.4V0.8V=1.6V. From
Vref(max)=1.3V we get R3=0
If R1=10k, we get R2=11.48R1=114.8kand IOH as follows, ingnoring RL (52):
IOH=1.6V(R1+R2)/R1R2
=1.6V(10k+114.8k)/10k114.8k=0.17mA
Hence, IOH<0.2mA. Therefore VOH(min)is ensured.
Next, assuming that VF(min)=0.5V for D2 in case of VOH(max), we get:
IOH=(5V0.5V)(R1+R2)/R1R2=0.49mA which is less than the rating.
Figure 1 shows the VOVC characteristics when R1=10k, R2=115k, R3=0, VIN=17V, RL=52, and D1=1S2076A(Hitachi).

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]