EVERLIGHT ELECTRONICS CO.,LTD.
19-217/BHC-AN1P2/3T
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Tel: 886-2-2267-2000, 2267-9936
ROfefilciea: bTNuoicl2hit5ey,nLgT,aTneeasi7pt6e,iIS2te3ec6m,3T,saCiAhwuannng,dRYa.COng.oCRndd, itions
Fax: 886-2267-6244, 2267-6189, 2267-6306
http://www.everlight.com
The reliability of products shall be satisfied with items listed below.
Everlight Electronics Co., Ltd.
Device No:SZDSE-197-B01
http://www.everlight.com
Prepared date:17-10-2006
Rev. 2
Page: 10 of 10
Prepared by: Bian Chang You